Perle Systems IOLINK-520 A.3

Event Logs

IOLINK-PRO & 520 Reference Manual —

A.3

DHCP services – release. <IP address> released.

Generated when IP address displayed is released from its assignment to a device and put back in the IP pool for re-

assignment.

Error executing: XXXXXX

Generated when an error is detected loading back a configuration. The invalid command is specified.

Incorrect password from <IP address>

Generated when an incorrect password is given for a Telnet connection. The connecting bridge/router’s

name or IP address is specified. After three incorrect login attempts within ten minutes, an alarm is generated

(see Security alarms: “Possible intruder”) and any further attempts from that IP address within the next ten

minutes are rejected.

Invalid Relay Destination for subnetted network

Generated when a device attempts to do a network broadcast on a subnetted network.

IP must be enabled on remote site <remote site id>

Generated when the Internet Protocol Control Protocol negotiations failed due to the remote site device having the

IPCP function disabled.

IPX: Network configuration error from X, network Y.

Generated when the router and server do not agree on a network number.

IPX: routing table full

Generated when the IPX RIP table has been filled. Any new RIP frames received will be discarded.

IPX: Service table full

Generated when the IPX SAP table has been filled. Any new SAP frames received will be discarded.

IPX: X, unknown RIP packet type received

Generated when the device receives an invalid RIP packet.

IPX: X, unknown SAP packet type received

Generated when the device receives an invalid SAP packet.

IPX: X, demand RIP failed

Generated when this device reaches the end of the attempts to negotiate demand RIP for the IPXCP

connection. After demand RIP has failed, the normal RIP and SAP updates will occur.

LCP X authenticating peer with CHAP

Generated when this device is using CHAP to authenticate the peer (remote) device.

LCP X authenticating peer with PAP

Generated when this device is using PAP to authenticate the peer (remote) device.

Contents

Main IOLINK-PRO & 520 Reference Manual 1.1 Section 1 Introduction The IOLINK-PRO & 520 Routers IP Routing and the IOLINK-PRO & 520 Routers 1.2 ARPAddress Resolution Protocol Proxy ARP The Complete IP Connection 1.3 1.4 IOLINK-PRO & 520 Reference Manual IP Header Details 1.5 ICMP Messages Page 1.7 RIPRouting Information Protocol 1.8 IPX Routing and The IOLINK-PRO & 520 Routers IPX Addressing 1.9 1.10 Establishing an IPX Connection Service Advertisement Protocol 1.11 Server Types Routing Information Protocol 1.12 Bridging and the IOLINK-PRO & 520 Routers 1.13 The Initial Bridging Process 1.14 Aging Timer 1.15 Filled Address Table 1.16 IOLINK Router Feature Definitions Telnet Link Compression 1.17 Figure 1 - 6 Typical Throughput Over 56 Kbps Link 1.18 WAN Topologies Bandwidth On Demand IOLINK-PRO & 520 Reference Manua 1.19 1.20 Disaster Recovery Backup Link ISDN Single Active Link & Dual Active Link Operating Software Upgrades 2.1 Section 2 ISDN Connection Management IOLINK PRO & 520 ISDN Connection Management Wide Area Network Topologies Supported Call Establishment Methods 2.2 Page 2.4 Connection Process Page 2.6 IP Specifics 2.8 IPX Specifics 3.1 Section 3 Link Interfaces Reference Pinout Information V.35 Module Identification: Link Clocking Information 3.2 ATL CSU/DSU Link Module Information 3.3 Console Pinouts 3.4 CSU/DSU Module: T1/E1 Module: CSU/DSU T1/E1 3.5 V.24 & RS232C Link Pinouts 3.6 V.11 & X.21 Link Pinouts 3.7 RS442 & RS530 Link Pinouts 3.8 V.35 Link Pinouts 3.9 RS232 Null-Modem Cable Configuration Figure 3 - 11 RS232 Null-Modem Cable 3.10 V.35 Null-Modem Cable Configuration Figure 3 - 12 V.35 Null-Modem Cable 3.11 RS530 Null-Modem Cable Configuration Figure 3 13 RS530 Null-Modem Cable 3.12 RS530 To RS449 Conversion Cable Figure 3 14 RS530 to RS449 Conversion Cable 3.13 V.11/X.21 Null-Modem Cable Configuration 3.14 WAN Link Control-Signal Operation A.1 Appendix A - Event Logs Event logs: A.2 A.3 A.4 A.5 A.6 A.7 Page IOLINK-PRO & 520 Reference Manual A.9 Alarm Logs: A.10 A.11 A.12 A.13 A.14 Code Description A.15 A.16 A.17 A.18 A.19 A.20 PPP Security Logs: B.1 Appendix B - Programmable Filtering MAC Address Filtering Security B.2 B.3 B.4 B.5 B.6 B.7 Pattern Filter Operators Bridge Pattern Filtering Protocol Discrimination B.8 B.9 B.10 Bandwidth Conservation B.11 General Restrictions B.12 B.13 IP Router Pattern Filtering Protocol Discrimination IPX Router Pattern Filtering Page Appendix C - Frame Formats Frame Formats C.2 ETHERNET TYPE CODES Octet Locations on an IP Routed TCP/IP Frame