200VW8 LCD
66
Remark: At first power on w/o signal LED will be orange blinking + message on screen.
7.2Standard Test conditions
Unless otherwise specified, this specification is defined under the following conditions.
(1) Input signal : | As defined in Timing table, 1680 x 1050 |
| |
| sources must have 75 ohm output impedance. |
(2) Luminance setting | : controls to be set to 300 nits with |
| full screen 100 % duty cycle white signal |
(3) Warm up: | more than 30 minutes after power on with signal supplied. |
(4) Ambient light: | 400 – 600 lux. |
(5)Ambient temperature: 20 ± 5 °C
7.3Test equipment
Personal computer with Windows 98/2000/XP Luminance meter Minolta CA110
Videogenerator: Chroma 2000, 2135, 2250 or equivalent
Colour analyzer: Minolta or Chroma 10 times magnifier
Ruler / Template Thickness gauge Watt / Power Meter
7.4Video Generator test sequence
Will be defined by TVI or its subcontracted quality providers.
7.5 | Analog input |
|
| Analog input R,G,B level: | 0 - 850 mV max. |
| Polarity: | positive, negative |
| Impedance: | 75 Ω ± 1% |
| Sync: | HV separate sync, composite sync, |
7.6Optical response time
Video Bandwidth: | 165 MHz (dot rate) |
Typical rise time | 5 ms |
7.7Protection circuit
The monitor will not be damaged by:
missing vertical or horizontal sync pulse
improper vertical or horizontal sync pulse (picture must be black at improper signals, unsynchronized pictures are not allowed)
7.8DDC
The monitor can support DDC 2 B and
