Philips 200VW8FB Electronic Instruction, DDC instructions General DDC Data Re-programming

Electronic Instruction

200VW8 LCD

17

7.Press AUTO icon of the toolbox and make sure all of the setting are fixed, then press the RUN icon. Program will perform the loading process automatically.

8.When the loading process completed, and the dialog box appeared the message of verify ok. Press the DIS-CONicon to disconnect the linkage, LED of monitor will light up.

DDC instructions

General

DDC Data Re-programming

In case the DDC data memory ICwhich storage all factory settings were replaced due to a defect, the serial numbers have to be re-programmed.

It is advised to re-soldered DDC IC from the old board onto the new board if circuit board have been replaced, in this case the DDC data does not need to be re-programmed.

*According to the design concept of this product, DDC data will be divided into two parts to deposit in different place: DDC data of VGA interface are saved in scaler IC.

Additional information

Additional information about DDC (Display Data Channel) may be obtained from Video Electronics Standards Association (VESA). Extended Display Identification Data(EDID) information may be also obtained from VESA.

System and equipment requirements

1.An i486 (or above) personal computer or compatible.

2.Microsoft operation system Windows 98/2000/XP.

3.Installation software of " TVI Tool ".

4.Executive program " TVI Tool. exe ".

5.ISP tool kit, as shown in Fig1. Including: a. Alignment fixture x 1

b.Printer cable (LPT type) x 1

c.D-sub to D-sub cable x 1

Monitor(A) PC Monitor (B)

Tographicscard ToLPT1 port ISPTOOL

Fig. 1

Install and setup TVI-TOOLprogram

To monitor

Step 1: Create a folder in your PC, for example : D:\TVI-TOOL.

Step 2: Copy the installation file into the folder.

Step 3: Double click the INSTALL icon as shown in the Fig.2.

Step 4: Following the installation wizard, complete the whole installing progress.

Step 5: Restart your PC to

(More details are shown in the next page)