7.Troubleshooting | > |
In case of YPbPr connection
–’YPbPr’ is not selected in the menu and ‘Auto Source’ is activated. In this case ‘Auto Source’ will not recognize ‘YPbPr’.
•Select ‘YPbPr’ as projection source in the ‘Set up’ menu (‘Auto Component Selection’ sub menu).
In case of RGBsog (Scart) connection
–’RGBsog’ is not selected in the menu and ‘Auto Source’ is activated. In this case ‘Auto Source’ will not recognize ‘RGBsog’.
•Select ‘RGBsog’ as projection source in the ‘Set up’ menu (‘Auto Component Selection’ sub menu).
Poor colour • Adjust ‘Brightness’, ‘Contrast’, ‘Tint’ or ‘Hue’ (see ’Picture adjustment’ under ‘Operation’ - ‘On Screen Display Menu’).
•Reset all projector settings in the ‘Set up’ menu (‘Factory reset’).
Note | Please note that all other projector settings will be reset as well. |
Image is blurred
Picture rolls
No sound
The projector does not react to commands from the remote control
In case of YPbPr or RGBsog (Scart) connection
–Wrong component source selected in the menu:YPbPr i.s.o. RGBsog or vice versa.
•Check what source has been connected (‘YPbPr’ or ‘RGBsog’) and select this source the ‘Set up’ menu (‘Auto Component Selection’ sub menu).
–Image is not focused.
• Adjust focus ring.
–Distance between projector and screen is not correct.
•Adjust the distance between the projector and the screen. Please check the ‘Projector Assistant’ programme on the
–Signal cable is not correctly connected.
• Connect signal cable correctly.
–Signal cable is not correctly connected.
• Connect signal cable correctly.
–Audio cable is not correctly connected.
• Connect audio cable correctly.
–Volume is not adjusted properly.
•Adjust volume.
–
•Cancel
–Distance is too great.
• Reduce distance.
–Batteries are exhausted.
•Replace batteries (see ‘Inserting the batteries in the remote control’).
–IR sensor is obstructed.
• Remove obstacle.
Philips Multimedia Projector | 35 | English User guide bClever SV1 |
|
|
|
