xp CDR 600/00_01 English
Troubleshooting
WARNING
Under no circumstances should you try to repair the set yourself as this will invalidate the guarantee. Do not open the set as there is a risk of electric shock.
If a fault occurs, first check the points listed, before taking the set for repair. If you are unable to solve a problem by following these hints, consult your dealer or service centre.
Laser safety
This unit employs a laser. Only a qualified service person should remove the cover or attempt to service this device, due to possible eye injury.
ProblemSolution:
No power | – ensure that the ON/OFF key is in the on position (red LED on): |
| the CD recorder is in standby mode, press any key to activate it |
| – make sure that the power cable is plugged in correctly |
| – switch the recorder OFF and then immediately back ON |
|
|
No sound | – check the audio connections |
| – try using a different source on the amplifier |
|
|
Amplifier sound is distorted | – make sure that the CD recorder analog output is not connected to the |
| amplifier Phono input |
|
|
Play will not start | – make sure that the label of the CD is facing up |
| – clean the disc |
| – make sure that the disc is not defective by trying another disc |
|
|
Remote control does not work | – press CDR on the remote control and try again |
| – point the remote control directly at the CD recorder |
| – check the batteries and replace if necessary |
| – select the right source first |
|
|
Will not record | – clean the disc |
| – check if CDR(W) is an unfinalized disc |
| – check that the disc is recordable and replace if necessary |
| – the disc is not an AUDIO disc (WRONG DISC) |
| – wrong input source chosen. Input label flashing (CHECK INPUT) |
| – try using a Philips Audio CDR(W) |
|
|
Recording is distorted | – make sure the recording level is correct |
|
|
20 second pause between recordings | – see “Autostart recording“. |
|
|
Recorder does not react | – switch the ON/OFF button on the front of the recorder off and back on |
|
|
DISC RECOVER on display | – a power failure has occurred during recording; the CD recorder is attempting |
| to repair the disc |
|
|
DISC ERROR appears on the display | – the disc cannot be recorded further, and cannot be finalized. |
| – on a CDRW disc, the track being recorded is lost, but further recording and |
| finalization can still be done |
|
|
Recorded tracks do not start or stop | – try another auto track setting |
at the correct time or tracks have | – check if there are at least 2.7 seconds silence in between the tracks |
been merged together | (analog recording only) |
| – insert track increments manually with the remote control |
|
|
START SOURCE indication | – start the synchronized external recording by pressing PLAY on the external |
| source you wish to record from. |
English
27
