Press the UPC key to accept the terms and conditions.A short description of all the features in the Digital Cable Receiver with a UPC subscription will be displayed, and a test will start to check that setup is done correctly.
Search failure
In case of channel search failure, before starting a new search, check the following points:
•RF cable condition and connection to your Digital Cable Receiver as described in chapter Connect
•Signal quality
•Correct activation code is entered
Note
If the same failure message appears after a while, refer to chapter Frequently asked questions. If the problem remains, contact your dealer.
5Using your Digital Cable Receiver
Once you have connected the Digital Cable Receiver, use the remote control to operate the basic,
You will also become familiar with the handy Programme Information Bar.This is used to display information on the programme you are watching, search for another programme, or change channels.
5.1Switching the Digital Cable Receiver on and off
•Press the UPC key on the remote control to switch on the Digital Cable Receiver.
•Press
to switch off the Digital Cable Receiver.
Tip
You can also switch on the Digital Cable Receiver by pressing the CH+/- keys, and set it to standby by pressing the
button on the front of the Digital Cable Receiver.
5.2Changing channels
There are various ways of using the remote control to quickly change channels.
Zapping
Press CH+/- to quickly switch between adjacent channels.
•Press CH+ once to change from channel 1 to channel 2.
•Press CH- once to change from channel 2 to channel 1.
Tip
You can also use the 
,
,
and 
buttons on the front panel of the Digital Cable Receiver to quickly switch between adjacent channels.
71 | Using your Digital Cable Receiver |
