Philips DSX 5375 Safety Instructions CONT’D, General Information, Part 68 Analog Device Warnings

SAFETY INSTRUCTIONS (CONT’D)

NOTE TO CATV SYSTEM INSTALLER	interference to radio or television reception (which you can
Article 820-40 of the NEC (National Electrical Code)	determine by turning the equipment off and on), you are
	encouraged to try to correct the interference by one or
provides guidelines for proper grounding and, in particular,
	more of the following measures:
specifies that the cable ground shall be connected to the
grounding system of the building, as close to the point cable	1. Change the position of the Satellite Receiver with respect
entry as practical.	to the radio or television equipment that is receiving the
WARNING	interference.
	2. Move the Satellite Receiver away from the equipment that
This device complies with Part 15 of the FCC (U.S.A.) Rules.
	is receiving the interference.
Operation is subject to the following two conditions:
	3. Plug the Satellite Receiver into a different outlet so that
(1) This device may not cause harmful interference, and	the Satellite Receiver and the equipment receiving the
(2) This device must accept any interference received, includ-	interference are on different branch circuits.
ing interference that may cause undesired operation.	4. Use shielded cables and I/O cords with this equipment
FCC Regulations and Information	to comply with the relevant FCC regulations.
This equipment has been tested and found to comply with	5. If these measures do not eliminate the interference, you
	should consult your dealer or an experienced radio/
the limits for a Class B digital device, pursuant to Part 15 of
	television technician for help.
the FCC Rules.These limits are designed to provide reason-
able protection against harmful interference in a residential	IMPORTANT
installation.This equipment generates, uses and can radiate	Any change or modifications to the equipment by the user
radio frequency energy and, if not installed and used in accor-
	not expressly approved by the warranty or manufacturer
dance with the instructions, may cause harmful interference
	could void the user’s authority to operate the equipment.
to radio communications.
	Domestic use U.S.A – For units used at 100-120V, use only
However, there is no guarantee that interference will not
	the power supply cord which is supplied with the product.
occur in a particular installation. If this equipment does cause

GENERAL INFORMATION

Federal Communication Commission (FCC)	temporary interruption of service may be required. But if
Part 68 ANALOG DEVICE WARNINGS	advance notice isn't practical, the telephone company will
This equipment complies with part 68 of the FCC rules.	notify the customer as soon as possible.Also, you will be
	advised of your right to file a complaint with the FCC if
A label on the rear panel of this equipment contains,
	you believe it is necessary.
among other information, the FCC registration number
	The telephone company may make changes in its facilities,
and ringer equivalence number (REN) for this equipment. If
	equipment, operations or procedures that could affect the
requested, this information must be provided to the tele-
	operation of the equipment. If this happens, the telephone
phone company.
	company will provide advance notice in order for you to
The REN is used to determine the number of devices
	make necessary modifications to maintain uninterrupted
which may be connected to the telephone line. Excessive
	service.
RENs on the telephone line may result in the devices not
	If the equipment is causing harm to the telephone network,
ringing in response to an incoming call. In most, but not all
	the telephone company may request that you
areas, the sum of RENs should not exceed five (5.0).To be
	disconnect the equipment until the problem is resolved.
certain of the number of devices that may be connected
	This equipment cannot be used on public coin phone serv-
to a line, as determined by the total RENs, contact the local
telephone company.	ice provided by the telephone company. Connection to
Note: RENs are associated with loop-start and	party line service is subject to state tariffs. (Contact the
	state public utility commission, public service commission
ground-start ports. Do not use for E & M or digital
	or corporation commission for information.)
ports.
	For repair or warranty information on hardware service
This equipment uses the following USOC jack: RJ-11C.
	only, please call:
No modular plug is provided with this equipment.
	1-800-464-1131.
If the DSX 5350 causes harm to the telephone network,
the telephone company will notify you in advance that

4