Philips PFL38X7K, PFL38X7H Satellite settings, Update channel list, Install satellite channels

Update channel list

When the TV was switched on for the first time, a full installation of channels was performed.

By default, when there are changes to these channel lists, the TV updates them automatically. You can also switch off the automatic update or manually update the channels.

Note: If you are prompted to enter a code, enter '8888'.

Automatic update

To add or remove digital channels automatically, leave the TV in standby mode. The TV updates channels and stores new channels everyday. Empty channels are removed from the channel list.

Switch off the channel update message

If a channel update is performed, a message is displayed at startup. You can switch off this message.

1.Press .

2.Select [Setup] > [Channel settings] or

[Satellite settings].

3.Select [Channel installation] > [Channel update message].

4.Select [Off], then press OK.

To switch off automatic updates

In the [Channel installation] menu, select [Automatic channel update] > [Off].

Update channels manually

1.Press .

2.Select [Setup] > [Search for channels] >

[Update channels], then press OK.

3.Follow the onscreen instructions to update the channels.

EN 28

Satellite settings

What you can do

View satellite channels

Note:

∙Satellite signal is available on certain

models only.

[Search for satellite] is only available if the TV supports DVB-S.

∙To receive satellite channels, connect a satellite receiver to the SAT connector on your TV.

LNBs

This TV can receive signals from 4 different low noise block-down converters (LNBs). An LNB is mounted at the end pole of the dish antenna and captures signals from a satellite.

Install satellite channels

Install satellite channels

1.While you watch TV, press .

2.Select [Setup] > [Search for satellite] >

[Reinstall channels].

3.Follow the onscreen instructions to complete the installation.

4.Once complete, select [Finish], then press OK.

Select connection type

While you install satellite channels, you need to set the connection type. The number of LNBs on your dish antenna determines the number of satellite channels you can install.

1.After you select [Reinstall channels], select [Settings] and then press OK.

2.Select [Connection type].

3.Select a setting, then press OK.

∙[OneLNB]: Select if you have only one LNB.

∙[DiSeqC Mini (2 LNBs)]: Select if you have 2 LNBs.

∙[DiSeqC 1.0 (3-4 LNBs)]: Select for 3 or 4 LNBs.