F6 Pz´ xvˇˇ v z
If, contrary to expectation, you have any problems using this video recorder, it may be caused by one of the reasons mentioned below. You can also call the x
xz in your country.
You will find the phone number in the enclosed guarantee leaflet. Be prepared to give the model and production number to the customer service. Have the model number (MODEL NO) and the production number (PROD.NO) of your video recorder ready.
n y v w wz˚
•There is no power supply: check the power supply.
•A programmed recording is currently being made: if desired,
cancel the programmed recording with STANDBY/ON .
•Child lock is on: switch the child lock off.
•There is a technical problem: switch off the mains power supply for 30 seconds, then switch it on again. If this does not have any effect, you can:
1. Switch off the mains power supply again.
2. Then switch it on ¨ y | STANDBY | on the |
video recorder. |
|
|
3.Release the button when ’OSD’ appears in the video recorder display. All the information stored (TV channels, time and date, TIMER) will be cleared.
Rv ˚ ¸vıızy ˚
•Don’t use force. Pull out the mains plug for a moment.
gzı x y
•Remote control not pointed toward the video recorder: point it at the video recorder.
•There is a technical problem: Take out the batteries, wait for 10 seconds and place them back.
•Batteries have run out: change the batteries.
c v xv
•There is no recording on the cassette: change the cassette.
•You have selected the wrong programme number on the TV for playing cassette: on the TV, select the correct programme number for the video recorder.
•The cable connecting the TV set and the video recorder has come loose: check the cable.
e v xv
•Your TV set is not properly adjusted.
•The cassette badly worn or of poor quality: use new cassette.
•Tracking is not properly adjusted: turn to chapter ’PLAYBACK FUNCTIONS’ and read the section ’Tracking during playback’.
i¨z
•The TV channel you want to record is not stored or you selected the wrong programme number: check TV channels stored.
•You have loaded a cassette which cannot be recorded on: undo the erase protection on the cassette.
e y
•You have not set the TIMER properly: check the TIMER blocks.
•You have programmed the wrong time or date: check time and date.
•You have put in a cassette that cannot be recorded on: undo the erase protection on the cassette.
•’VPS/PDC’ switched on but ’VPS/PDCtime’ wrong: enter ’VPS/PDCtime exactly to the minute. Have your aerial checked.
•You have programmed a recording with ’SHOWVIEW’, but the programme number information of the TIMER block is not the programme number you want to record from:
1. Confirm the SHOWVIEW programming number with OK .
2.Press TIMER .
3.Change the programme number displayed in the ’PROG.’ entry field.
4. Confirm with TIMER .
i¨z ˚ ˚ ik
•Turn to chapter ’ADDITIONAL FUNCTIONS’ and read ’Reducing picture disturbance - optimizing the modulator’ and ’Switching off the modulator’.
•Have your aerial checked.
28
