76
CPP Monitor 2000 User’s Manual
To record a message, press the [#] key followed by the message
number you want. For example, to record the ID message, press [#]
then 9. After you hear the start beep, begin speaking into the phone.
You have until the second beep to complete your message. You have
6 seconds of recording time for the ID message and 4 seconds for
each of the 8 input messages.
To play back a message, press the [*] key followed by the message
number you want. For example, to play the ID message, press [*]
then 9.
To request a complete status report, press the [*] key twice.
Note: Since the unit can only communicate with one
device at a time, it will not answer any calls nor make
any calls while you are on-line in local voice mode.
Local Status Report
To receive a voice status report at the unit, plug a telephone into the
Voice Record jack. After a few seconds the unit will begin reciting
a status report. At the end of the report it will ask for a password.
The password is the Voice Password required to change voice
messages and acknowledge alarms. If entered correctly, the unit
will allow you to use the Touch-Tone commands to record/listen to
messages and acknowledge alarms. When finished simply hang up.
Status Report
To receive a voice status report remotely, call the unit and after you
hear the unit beep, press any Touch Tone within 3 seconds. The unit
will then recite a status report. If the unit starts its modem tone
sequence, simply wait until it finishes. A status report will begin as
soon the tones finish. At the end of the report it will ask for a
password. The password is the Voice Password required to change
voice messages and acknowledge alarms. If entered correctly, the
unit will allow you to use the Touch-Tone commands to record/
listen to messages and acknowledge alarms. When finished simply
hang up. The unit will disconnect itself automatically if no Touch-
Tone commands are received within 10 seconds.