Phonetics 2000 - page 84

84
CPP Monitor 2000 User’s Manual
Below is an example of what CPP Monitor 2000 will say when you
call it back to acknowledge a typical alarm:
“Hello, this is (user recorded ID message)”
“The electricity is off”
“Hello, this is (user recorded ID message)”
“The electricity is off”
“Hello, this is (user recorded ID message)”
“The electricity is off”
“Enter acknowledgment code.”
CPP Monitor 2000 will now wait 5 seconds for the Touch-Tone
acknowledgment code to be entered. After the last digit of the
acknowledgment code has been received, CPP Monitor 2000 will
respond by saying: “Alarm Acknowledged.” The alarm has been
acknowledged and the unit will hang up. Once the alarm has been
acknowledged, the dialout process stops.
If the Touch-Tone acknowledgment code is not received, CPP
Monitor 2000 will respond by saying: “beep,” “error,” “goodbye.” The
alarm has not been acknowledged. CPP Monitor 2000 will hang up
and wait for a callback acknowledgment. This waiting period is
called the “intercall delay time.” During this time you may call the
unit back from a Touch-Tone phone. Wait for the unit to beep.
Then hit any key on the phone, and the unit will give a voice report.
Once you receive the complete report, enter the code to acknowl-
edge the alarm. NOTE: An alarm cannot be acknowledged using a
pulse (rotary) telephone.
TIP: When CPP Monitor 2000 is programmed to make
calls to beepers, make sure the intercall delay time is
long enough to give the person carrying the beeper
some time to get to a phone to call the unit back.