03Connecting your equipment
1Twist exposed wire strands together.
2Loosen terminal and insert exposed wire.
3Tighten terminal.
1 | 2 | 3 |
10 mm (3/8 in.)
If you selected Surr.Back in The Speaker System setting on page 49, you can switch between speakers using the SPEAKERS button. If you selected Height, the button will simply switch your main speaker terminal on or off. The options below are for the Surr.Back setting only.1
•Use the SPEAKERS button on the front panel to select a speaker terminal setting.2
SPEAKERSDIMMERDISPLAY
1Twist exposed wire strands together.
2Push open the tabs and insert exposed wire.
3Release the tabs.
1 | 2 | 3 |
10 mm (3/8 in.)
CAUTION
•These speaker terminals carry HAZARDOUS LIVE voltage. To prevent the risk of electric shock when connecting or disconnecting the speaker cables, disconnect the power cord before touching any uninsulated parts.
•Make sure that all the bare speaker wire is twisted together and inserted fully into the speaker terminal. If any of the bare speaker wire touches the back panel it may cause the power to cut off as a safety measure.
Press repeatedly to choose a speaker terminal option:
•SPA – Sound is output from the speakers connected to the
•SPB – Sound is output from the two speakers connected to the
•SPAB – Sound is output from the A- speaker terminals, the two speakers in the
•SP– No sound is output from the speakers.
Note
1All speaker terminals (except Speaker B connections) are switched off when headphones are connected.
2The subwoofer output depends on the settings you made in Speaker Setting on page 45. However, if SPB is selected above, no sound is heard from the subwoofer (the LFE channel is not downmixed).
20
En