Pioneer 920 Pairing Bluetooth ADAPTER and Bluetooth wireless technology device

10Other connections

1Switch the receiver into standby and connect Bluetooth ADAPTER to the ADAPTER PORT located in the rear panel.

2Switch on the receiver.

3Press ADAPTER on the remote control to switch the receiver to ADAPTER input mode.1

Pairing Bluetooth ADAPTER and Bluetooth wireless technology device

“Pairing” must be done before you start playback of Bluetooth wireless technology content using Bluetooth ADAPTER. Make sure to perform pairing first time you operate the system or any time pairing data is cleared. “Pairing” is the step necessary to register Bluetooth wireless technology device to enable Bluetooth communications.2 For more details, see also the operating instructions of your Bluetooth wireless technology device.

1 Press TOP MENU.

4Switch on the Bluetooth wireless technology device that you want to make pairing, place it near the system and set it into the pairing mode.

5Check to see that the Bluetooth ADAPTER is detected by the Bluetooth wireless technology device.

When Bluetooth wireless technology device is connected:

Bluetooth wireless technology device name appears in the receiver display.3

When Bluetooth wireless technology device is not connected:

NODEVICE appears in the receiver display. In this case, perform the connection operation from the side of the Bluetooth wireless technology device.

6From the Bluetooth wireless technology

device list, select Bluetooth ADAPTER and enter the PIN code selected in the step 4.4

2Press ENTER to enter PAIRING.

3Select the PIN code to be used from 0000/ 1234/8888 using /, then press ENTER. PAIRING blinks.

Important

•You can use any of 0000/1234/8888 PIN codes. Bluetooth wireless technology device using any other PIN code cannot be used with this system.

Listening to Music Contents of Bluetooth wireless technology device with Your System

1Press ADAPTER on the remote control to switch the receiver to ADAPTER input mode.

2Perform the connection operation from the side of the Bluetooth wireless technology device to the Bluetooth ADAPTER.

Note

1When the Bluetooth ADAPTER is not plugged into the ADAPTER PORT, NO ADAPTER will be displayed if ADAPTER input mode is selected.

2• Pairing is required when you first use Bluetooth wireless technology device and Bluetooth ADAPTER.

• To enable Bluetooth communication, pairing should be done with both of your system and Bluetooth wireless technology device.

3The system can display alphanumeric characters only. Other characters may not be displayed correctly.

4PIN code may in some case be referred to as PASSKEY.