11Additional information

Problem

Remedy

During a playback search,

• This is not a malfunction, but be sure to turn the volume down to

noise is output from a DTS

prevent the output of loud noise from your speakers.

compatible CD player.

 

 

 

Everything seems to be set

• Check that the positive/negative speaker terminals on the receiver are

up correctly, but the

matched with the corresponding terminals on the speakers (see

playback sound is odd.

Connecting the speakers on page 19).

 

 

There seems to be a time

• See Automatically setting up for surround sound (MCACC) on page 31 to

lag between the speakers

set up your system again using MCACC (this will automatically

and the output of the

compensate for a delay in the subwoofer output).

subwoofer.

 

 

 

After using the Auto

• Low-frequency noise could have been caused by an air conditioner or

MCACC Setup, the speaker

motor. Switch off all appliances in the room and rerun the Auto MCACC

size setting (LARGE or

Setup.

SMALL) is incorrect.

 

 

 

Can’t operate the remote

• Replace the batteries (refer to page 7).

control.

• Operate within 7 m (23 ft.), 30° of the remote sensor (refer to page 10).

 

• Remove the obstacle or operate from another position.

 

• Avoid exposing the remote sensor on the front panel to direct light.

 

 

The display is dark or off.

• Press DIMMER on the control repeatedly to return to the default.

 

 

The Bluetooth wireless

• Check that no object that emits electromagnetic waves in the 2.4 GHz

technology device cannot

band (microwave oven, wireless LAN device or Bluetooth wireless

be connected or operated.

technology apparatus) is near the unit. If such an object is near the unit,

Sound from the Bluetooth

set the unit far from it. Or, stop using the object emitting the

wireless technology device

electromagnetic waves.

is not emitted or the sound

• Check that the Bluetooth wireless technology device is not too far from

is interrupted.

the unit and that obstructions are not set between the Bluetooth wireless

 

technology device and the unit. Set the Bluetooth wireless technology

 

device and the unit so that the distance between them is less than about

 

10 m (32 ft.) and no obstructions exist between them.

 

• Check that the Bluetooth ADAPTER and the ADAPTER PORT of the unit

 

are correctly connected.

 

• The Bluetooth wireless technology device may not be set to the

 

communication mode supporting the Bluetooth wireless technology.

 

Check the setting of the Bluetooth wireless technology device.

 

• Check that pairing is correct. The pairing setting was deleted from this

 

unit or the Bluetooth wireless technology device. Reset the pairing.

 

• Check that the profile is correct. Use a Bluetooth wireless technology

 

device that supports A2DP profile and AVRCP profile.

 

 

74

En