3Press RECEIVER on the remote control, then press the SETUP button.
An
control to navigate through the screens and select menu items. Press RETURN to exit the current menu.
6 Wait for the test tones to finish.
A progress report is displayed
1.Auto MCACC
Now Analyzing
•Press SETUP at any time to exit the System Setup menu.1
4Select ‘Auto MCACC’ from the System Setup menu then press ENTER.2
System Setup
1.Auto MCACC 2.Manual SP Setup 3.Input Assign 4.Speaker System 5.Video Parameter
Environment Check
Ambient Noise
Speaker YES/NO
Return
•For correct speaker settings, do not adjust the volume during the test tones.
7 Confirm the speaker configuration.
Return
Try to be as quiet as possible after pressing ENTER. The system outputs a series of test tones to establish the ambient noise level.
5Follow the instructions
•Make sure the microphone is connected.
•Make sure the subwoofer is on and the volume is turned up.
•See below for notes regarding background noise and other possible interference.
The configuration shown
•With error messages (such as Too much ambient noise) select RETRY after checking for ambient noise (see Other problems when using the Auto MCACC Setup on page 33).
1.Auto MCACC
Check!
Front | [ | YES ] | ||
Center | [ | YES ] | ||
Surr | [ | YES ] | ||
Surr. Back | [YESx2] | |||
Subwoofer | [ | YES ] | ||
|
|
|
|
|
10:Next |
|
| OK | |
|
| Return | ||
If the speaker configuration displayed isn’t correct, use / to select the speaker and / to change the setting. When you’re finished, go to the next step.
If you see an error message (ERR) in the right side column, there may be a problem with the speaker connection. If selecting RETRY doesn’t fix the problem, turn off the power and check the speaker connections.
Note
1The screensaver automatically starts after three minutes of inactivity. If you cancel the Auto MCACC Setup at any time, the receiver automatically exits and no settings will be made.
2MIC IN blinks when the microphone is not connected to MCACC SETUP MIC.
32
En