Pioneer 920 iPod messages, Important information regarding the HDMI connection

11Additional information

Important information regarding the HDMI connection

There are cases where you may not be able to route HDMI signals through this receiver (this depends on the HDMI equipped component you are connecting-check with the manufacturer for HDMI compatibility information).

If you aren’t receiving HDMI signals properly through this receiver (from your component), please try the following configuration when connecting up.

Configuration1

Connect your HDMI-equipped component directly to the display using an HDMI cable. Then use the most convenient connection (digital is recommended) for sending audio to the receiver. See the operating instructions for more on audio connections. Set the display volume to minimum when using this configuration.

iPod messages

Symptom	Cause	Action
iPod/USB Error 1 There is a problem with the signal path		Switch off the receiver and reconnect
(I/U ERR1)	from the iPod to the receiver.	the iPod to the receiver. If this doesn’t
		seem to work, try resetting your iPod.

iPod/USB Error 2 The software version being used with the

(I/U ERR2) iPod needs to be updated.

Update the software being used with the iPod (please use the latest iPod software versions later than the iPod updater 2004-10-20).

	An iPod not supported by this receiver is	Connect the iPod supported by this
	connected.	receiver.

iPod/USB Error 3 When there is no response from the iPod.		Update the iPod software to the latest
(I/U ERR3)		version. If this doesn’t seem to work, try
		resetting your iPod.

No Track	When there are no tracks in the category	Select a different category.
	selected on the iPod.

Note

1• If your display only has one HDMI terminal, you can only receive HDMI video from the connected component.

•Depending on the component, audio output may be limited to the number of channels available from the connected display unit (for example audio output is reduced to 2 channels for a monitor with stereo audio limitations).

•If you want to switch the input source, you’ll have to switch functions on both the receiver and your display unit.

•Since the sound is muted on the display when using the HDMI connection, you must adjust the volume on the display every time you switch input sources.