Addition — CLD-V2600 User’s Manual

#1 — 11/94

Additional Error Messages

The RS-232 Error Messages described on page 4-3 of the CLD-V2600 User’s Manual, also appear on the front panel illuminated display of CLD-V2600 players. There are two additional Error Messages that you may also see on the display. These two additional Error Messages are not returned in response to any RS-232 commands, but only appear on the front panel display. Here is a brief description of each:

1)E07 — Unrecoverable error

The player may read a portion of the disc, then spin it down. If the E07 error occurs when the player is reading material at the outside of the disc, check to make sure that the disc is not warped.

Lay the disc on a flat surface. If you can slide a dime under the center hole of the disc, it is warped. Check both sides. If the disc is warped, leave it on the flat surface, place several heavy books on it and leave it overnight. This will flatten out the disc, then you can try to play it again. Also, make sure the disc is free of scratches or greasy finger prints.

If the player still spins down the disc when searching or playing to the higher numbers of the disc, and you see the E07 error on the illuminated front panel, the player may need service. Call 1-800-872-4159 for your nearest Authorized Service Center.

2)E03 — Mis-clamp condition on spin-up

The player begins to spin up the disc, then immediately spins it down and you see the E03 error on the illuminated front panel of the player. This error can be caused by a disc that is out of specification. Try playing several different discs.

If the problem persists, and you see the E03 error on the front panel after trying to play several different discs, the player may need service. Call 1-800-872-4159 for your nearest Authorized Service Center.

Multimedia Systems Division, Engineering/Technical Support

201/327-6400