Pioneer DEH-P6000UB Adjusting loudness, Using subwoofer output, Adjusting subwoofer settings

	Section
Audio Adjustments	03

3Push MULTI-CONTROL left or right to select the equalizer band to adjust.

Each time MULTI-CONTROL is pushed left or right, equalizer bands are selected in the fol- lowing order:

50Hz—125Hz—315Hz—800Hz—2kHz— 5kHz—12.5kHz

4Push MULTI-CONTROL up or down to adjust the level of the equalizer band. Each time MULTI-CONTROL is pushed up or down, the level of the equalization band in- creases or decreases.

+6 to –6 is displayed as the level is increased

or decreased.

# You can then select another band and adjust the level.

5Press BAND to cancel the 7-band gra- phic equalizer adjustment.

1 Display the audio menu.

Refer to Introduction of audio adjustments on page 25.

#You can also select the subwoofer setting menu by pressing SW on the unit.

2Use MULTI-CONTROL to select Sub W.1.

3Press MULTI-CONTROL to turn subwoo- fer output on.

Normal appears in the display. Subwoofer out-

put is now on.

# To turn subwoofer output off, press MULTI-CONTROL again.

4Push MULTI-CONTROL left or right to select the phase of subwoofer output. Push MULTI-CONTROL left to select reverse phase and Reverse appears in the display. Push MULTI-CONTROL right to select normal phase and Normal appears in the display.

Audio Adjustments

Adjusting loudness

Loudness compensates for deficiencies in the low- and high-sound ranges at low volume.

1 Display the audio menu.

Refer to Introduction of audio adjustments on page 25.

2Use MULTI-CONTROL to select LOUD.

3Press MULTI-CONTROL to turn loudness

on.

Loudness level (e.g., Mid) appears in the dis-

play.

# To turn loudness off, press MULTI-CONTROL again.

4Push MULTI-CONTROL left or right to select a desired level.

Each time MULTI-CONTROL is pushed left or

right, level is selected in the following order: Low (low)—Mid (mid)—High (high)

Using subwoofer output

This unit is equipped with a subwoofer output which can be turned on or off.

Adjusting subwoofer settings

When the subwoofer output is on, you can ad- just the cut-off frequency and the output level of the subwoofer.

Only frequencies lower than those in the se- lected range are outputted from the subwoo- fer.

!When the subwoofer output is on, you can select Sub W.2.

1 Display the audio menu.

Refer to Introduction of audio adjustments on page 25.

#You can also select the subwoofer setting menu by pressing SW on the unit.

2Use MULTI-CONTROL to select Sub W.2.

3Push MULTI-CONTROL left or right to select cut-off frequency.

Each time MULTI-CONTROL is pushed left or right, cut-off frequencies are selected in the following order: 50Hz—63Hz—80Hz—100Hz—125Hz

En 27