| Section |
Initial Settings | 04 |
|
|
!For this function, verify the topic Adjusting initial settings before initiating the opera- tion.
1Display the intial setting menu.
2Use
3Press
on.
# To turn dimmer off, press
Adjusting the brightness
You can adjust the display brightness.
!For this function, verify the topic Adjusting initial settings before initiating the opera- tion.
1Display the intial setting menu.
2Use
3Push
0to 15 is displayed as the level is increased or
decreased.
# When dimmer is functioning, the brightness level can be adjusted 0 to 10.
2Use
3Press
Pressing
will be displayed.
# When no subwoofer is connected to the rear
output, select Rear SP :F.Range.
# When a subwoofer is connected to the rear output, set for subwoofer Rear SP :S/W.
Notes
!Even if you change this setting, there is no output unless you turn the subwoofer output on (refer to Using subwoofer output on page 27).
!If you change this setting, subwoofer output in the audio menu return to the factory set- tings.
!Both rear speaker lead outputs and RCA rear
output are switched simultaneously in this setting.
Switching the sound muting/attenuation
Initial Settings
Setting the rear output and subwoofer controller
This unit’s rear output (rear speaker leads out- put and RCA rear output) can be used for full- range speaker (Rear SP :F.Range) or subwoo- fer (Rear SP :S/W) connection. If you switch the rear output setting to Rear SP :S/W, you can connect a rear speaker lead directly to a subwoofer without using an auxiliary amp. Initially, the unit is set for rear
!For this function, verify the topic Adjusting initial settings before initiating the opera- tion.
1 Display the intial setting menu.
Sound from this system is muted or attenu- ated automatically when the signal from the equipment with mute function is received.
!The sound is muted or attenuated, MUTE or ATT are displayed and no audio adjust- ment is possible.
!Sound from this system returns to normal when the muting or attenuation is can- celed.
!For this function, verify the topic Adjusting initial settings before initiating the opera- tion.
1Display the intial setting menu.
2Use
En 31