Attach the included rack mount brackets to the screw holes in the side of this unit using the included screws, four screws per side.

Rack mount bracket

Screw holes in side

Included screws

•When attaching, first tighten the four included screws temporarily so that the rack mount bracket still moves when a light force is applied, check that the rack mount bracket is properly attached, then tighten the screws to fasten the rack mount bracket securely.

•If the rack space in which this unit is to be installed is only 1U size, proceed to step 3.

•If the rack space in which this unit is to be installed is greater than 1U size and there is space of more than 10 mm under this unit, proceed to step 4.

3Turn this unit upside-down and remove the four feet.

Use a flat-blade screwdriver to turn the “–” part of the plastic screw section on the foot counterclockwise, loosen until the plastic screw section’s head comes out of the foot, then remove the foot from this unit.

Plastic screw

Remove foot

Foot fixing hole

•The feet will be needed again if this unit is installed without using a rack, so be sure to store them in a safe place.

•To reinstall the feet on this unit, insert the foot into the foot fixing hole in this unit, then press the plastic screw section in.

•Do not mount anything other than the feet that were removed (including the plastic screw section). Mounting other feet may damage this unit. If you lose the feet, contact the after-sales service center (indicated on the rear panel).

4 Mount this unit on the rack.

Check that the screws fastened in step 2 are securely tightened.

This unit

Rack

(Conforming to EIA standards)

Rack mount

mounting screw holes

Screws (*)

Rack mount

 

brackets

Screws (*)

5Check that the screws fastened in step 4 are securely tightened.

Once this is checked, mounting is completed.

•If the * screws or the rack mount bracket’s screws are loose, vibrations generated by other products could cause noise or to lead this unit falling off the rack, resulting in injury or damage to the equipment. Be sure to check that the screws are securely fastened.

Caution

•Pay attention to the following when removing this unit from the rack and moving it:

–Be sure to remove any SD memory card from this unit.

–Turn this unit’s power off, then disconnect connected cables, etc.

–Be careful that this unit does not fall when loosening the screws fastening it to the rack (the procedure should be performed by at least two people).

–After removing this unit from the rack, be sure to place it on a stable surface, such as on a flat table.

•When wiring after installing this unit, fasten the cables to the rack. If your feet get caught in the cables, a strong force could be exerted on this unit’s terminals, damaging this unit.

02

English

29

En