Problem

•An error occurs while files are being loaded/saved.

•USB READ ERROR or USB WRITE ERROR is displayed.

CheckRemedy

Is the USB storage device write- Turn this unit’s power off (to standby), then cancel the USB storage

protected?

device’s write protection function.

 

 

Is the USB storage device’s file

Only USB storage devices formatted with a FAT16, FAT32 or NTFS

system proper?

file system can be used.

 

 

 

• Turn this unit’s power off (to standby), then turn it back on.

 

• Reconnect the USB storage device. If the error occurs again,

 

format the device in FAT format on a computer, then load/store the

 

data.

10

Others

Problem

Check

Remedy

This unit cannot be

 

Check the Baud Rate (page 47) setting and serial interface

controlled by RS-232C.

 

specifications (page 64).

 

 

 

• This unit’s power turns off

Is Auto Power Off set to Enable?

When Auto Power Off is set to Enable, this unit’s power

(to standby) automatically.

 

automatically turns off (to standby) if no operation is performed for

• Power turns off (to standby)

 

over two hours (page 47).

during continuous operation.

 

 

Is HIGH TEMPERATURE AUTO

This happens when this unit’s internal remains high during

 

TURNED OFF displayed on the

operation for an extended period of time. Check this unit’s

 

main unit display?

installation conditions.

 

 

 

Remote control does not

Are you operating from too far

Operate the remote control within a range of seven meters from

work.

away from this unit?

the remote control sensor.

 

 

 

 

Is the remote control locked?

When the IR indicator on the main unit’s front panel is lit, operation

 

 

of the remote control is locked. Press the LOCK button to unlock it.

 

 

 

 

Is the RS-232C key lock command

Cancel the key lock command. For details, see the

 

set?

Communications Interface User’s Manual.

 

 

 

Buttons on the main unit’s

Are the buttons locked?

• Set Front Key to Enable (page 47).

front panel do not operate.

 

• Press the STANDBY/ON button for 10 seconds or more to turn

 

 

the power off (to the standby mode) (page 25). If the STANDBY/

 

 

ON button does not work, unplug the power cord, wait for the

 

 

STANDBY/ON indicator to turn off, then plug the power cord

 

 

back in.

 

 

 

Settings you have made have

• Has the power cord been

Be sure to press the STANDBY/ON button and wait until the

been cleared.

unplugged while this unit’s power

POWER OFF message on the main unit’s display turns off before

 

was on?

unplugging the power cord. Be particularly careful when this unit’s

 

• Has there been a power outage?

power cord is connected to the AC outlet on another device, as this

 

 

unit’s power will turn off (to standby) together with the power of the

 

 

other device.

 

 

 

Time is not displayed

 

This unit’s clock has a precision of about two minutes per month.

properly.

 

The setting is cleared if the power cord is left unplugged for 7 to 10

 

 

days.

 

 

 

External synchronization is

Is External Sync set to Off?

Set External Sync set to On (page 46).

not possible.

 

 

Is UNMATCHED EXT SYNC

• Check that the sync generator is properly connected (page 48).

 

 

SIGNAL displayed?

• Set the sync generator’s frequency properly.

 

 

• Check that the sync generator’s frequency is being output

 

 

properly.

• The synchronizing signal’s format is not matched. Set the external synchronizing signal, playback file and Scaler Setting to the same resolution (page 46).

English

79

En