Pioneer HD-V9000 43

Switching the resolution

Use the procedure below to switch the resolution of the video signals output from COMPONENT VIDEO OUT terminal, HDMI OUT terminal.

STANDBY/ON

SEARCH REPEAT MEMORY RECALL

	OUTPUT
	RESOLUTION
	+
	-
	DISPLAY
FRM
/TIME
NAVI-	PLAY
GATOR	MODE
SETUP	RETURN

Displaying the firmware version and serial number

STANDBY/ON

SEARCH REPEAT MEMORY RECALL

	OUTPUT
	RESOLUTION
	+
	-
	DISPLAY
FRM
/TIME
NAVI-	PLAY
GATOR	MODE
SETUP	RETURN

English

Caution

•With some devices (TVs, AV amplifiers, etc.), the picture or sound may not be output properly if the resolution is switched. If this happens, use the OUTPUT RESOLUTION (+, –)buttons to set a resolution at which the picture or sound is output properly.

•When outputting with a resolution of 1920 x 1080p, 1920 x 1080i or 1280 x 720p from the HDMI OUT or COMPONENT VIDEO OUT terminals, the signals may be output with a ratio of 16:9, even when TV Screen is set to 4:3 (page 46).

•The picture may not be displayed for several seconds when the resolution is switched.

1Press one of the OUTPUT RESOLUTION (+, –) buttons.

The resolution switches each time the button is pressed.

•The current resolution setting can be checked on the main unit display. Press the LCD button on the main unit’s front panel to switch the resolution display.

•The resolution can also be switched at Scaler Setting (page 46).

1With playback stopped, press and hold the DISPLAY button for over 1 second.

The display switches as shown below.

•The firmware version and serial number can also be displayed by pressing the DISPLAY button on the main unit’s front panel.

Version number


V e r .		0			1	. 0 0

S	N .	J A T W	0 1 2 3	4		5 J P


Serial number		Serial number – 12 digits are displayed

•To check on the display, see Information display (System Information) on page 52.