Pioneer Using the Battery, Recharging the battery pack PDV-LC10 only, Recharge lamp

Using the Battery

Recharging the battery pack (PDV-LC10 only)

Recharge the battery pack as described below.

1

2

BEFORE USING	3	Recharge lamp
		CHARGE
		1

2

Battery pack (PDV-BT10)

Charger (VWY 1060)

Note:

The battery charger is compatible with supply voltages between 100 and 240 V AC and can be used universally. When you want to use it on an overseas travel, however, be sure to prepare a power plug

36 adapter matching the local power outlet.

1Connect the power cord to the battery charger.

2Connect the power plug to the power outlet.

3Fit the battery pack into the

battery charger.

Fit sections 1 then 2 securely.

•When recharging starts, the recharge lamp lights in red. If the recharge lamp blinks, the battery pack is not being recharged; wait a while before trying to recharge again.

•The recharge lamp goes out when recharging completes. After confirming that the lamp is extinguished, remove the battery pack and power cord.

•Recharging usually completes in about 2 hours 30 minutes, though this is variable depending on the operating conditions.

Notes on the battery pack

•The battery pack can be used for about 300 cycles of recharging and operations, though this is variable depending on the operating conditions.

•Charge the battery pack fully before using it for the first time.

CAUTION

•Place the battery charger on a level, flat surface for recharging.

•Do not short-circuit the terminals of the battery charger.

En