Techno Tidbits &
Specifications
Amplifier Section
Continuous average power output of 120 watts* per channel, min., at 6 ohms, from 20 Hz to 20,000 Hz with no more than 0.09 %** total harmonic distortion (front).
Continuous Power Output | W (20 | |
Front | 120 W + 120 | |
Center | 120 | W (20 |
Rear | 120 W + 120 | W (20 |
Audio Section
Input (Sensitivity/Impedance) | 4.7 mV/47 kΩ | |
PHONO MM |
| |
VCR 1/DVR, VCR 2, DVD/LD, TV/SAT, VIDEO, CD | ||
MD/TAPE | ................... 335 mV/47 kΩ | |
Phono Overload level (T.H.D.0.1 %, 1kHz) | ||
PHONO MM | 120 mV | |
Frequency Response |
|
|
PHONO MM | 20 Hz to 20,000 Hz ± 0.3 dB | |
VCR 1/DVR, VCR 2, DVD/LD, TV/SAT, VIDEO, CD +0 | ||
MD/TAPE | 5 Hz to 100,000 Hz |
Output (Level/Impedance)
VCR 1/DVR REC, VCR 2 REC, MD/TAPE
TAPE 2 REC | 335 mV/2.2 kΩ |
Tone Control |
|
BASS | ± 6 dB (100 Hz) |
TREBLE | ± 6 dB (10 kHz) |
LOUDNESS | +10 dB (100 Hz/10 kHz) |
PHONO MM | 80 dB |
VCR 1/DVR, VCR 2, DVD/LD, TV/SAT, VIDEO, CD | |
MD/TAPE 1, TAPE 2 | 103 dB |
MULTI CHANNEL IN ..... 103 dB(Channel Level:Bypass) | |
PHONO MM | 80 dB |
VCR 1/DVR, VCR 2, DVD/LD, TV/SAT, VIDEO, CD | |
MD/TAPE | 83 dB |
*Measured pursuant to the Federal Trade Commission’s Trade Regulation rule on Power Output Claims for Amplifiers.
**Measured by Audio Spectrum Analyzer.
Video Section |
|
|
|
Input (Sensitivity) |
| 1 | |
Output (Level/Impedance) | 1 | ||
| 65 dB | ||
Frequency Response | 5 Hz to 10 MHz | ||
Component Video Section |
| ||
Input (Sensitivity) |
| 1 | |
Output (Level/Impedance) | 1 | ||
| 65 dB | ||
FM Tuner Section |
|
|
|
Frequency Range | 87.5 MHz to 108 MHz | ||
Usable Sensitivity | Mono: 13.2 dBf, IHF (1.3 µV/75 Ω) | ||
50 dB Quieting Sensitivity | Mono: 20.2 dBf | ||
|
|
| Stereo: 38.6 dBf |
Mono: 73 dB (at 85 dBf) | |||
|
| Stereo: 70 dB (at 85 dBf) | |
Distortion | Stereo: 0.5 % (1 kHz) | ||
Alternate Channel Selectivity | 60 dB (400 kHz) | ||
Stereo Separation |
| 40 dB (1 kHz) | |
Frequency Response | 30 Hz to 15 kHz (± 1) dB | ||
Antenna Input |
| 75 Ω unbalanced | |
AM Tuner Section |
|
| |
Frequency Range | 530 kHz to 1,700 kHz | ||
Sensitivity (IHF, Loop antenna) | 350 µV/m | ||
Selectivity |
| 25 dB | |
| 50 dB | ||
Antenna |
| Loop antenna | |
Miscellaneous |
|
|
|
Power Requirements |
| AC 120 V, 60 Hz | |
Power Consumption |
| 460 W, 630 VA | |
Power Consumption in Standby mode | .................... 1.0 W | ||
AC Outlet |
|
|
|
SWITCHED (×2) | Total 100 W (0.8 A) MAX | ||
UNSWITCHED |
| 100 W (0.8 A) MAX | |
Dimensions | 457 (W) × 174 (H) × 470 (D) mm | ||
Weight (without package) | 17.2 kg (37 lb 15 oz) | ||
Furnished Parts |
|
|
|
FM wire Antenna |
| 1 | |
AM Loop Antenna |
| 1 | |
“AA” IEC LR6 batteries | .................................................. | 4 | |
Remote Control Unit |
| 1 | |
Touch Pen |
| 1 | |
Cushion for Remote |
| 4 | |
Operating Instructions |
| 1 |
Maintenance of External Surfaces
•Use a polishing cloth or dry cloth to wipe off dust and dirt.
•When the surfaces are dirty, wipe with a soft cloth dipped in some neutral cleanser diluted five or six times with water, and wrung out well, and then wipe again with a dry cloth. Do not use furniture wax or cleaners.
•Never use thinners, benzine, insecticide sprays or other chemicals on or near this unit, since these will corrode the surfaces.
NOTE:
Specifications and the design are subject to possible modifications without notice, due to improvements.
90