Remote Control of Other Components
MD operations
memo • The following operations are available from the receiver's remote control after you program your MD recorder into it, but some operations may need to be learned separately by the re-
ceiver (see “Setting Up the Remote Control to Control Other Components,“
•To perform these operations, press the MD/TAPE1 button to set the remote to the MD operation mode.
•For more information on individual commands consult the manual that came with the component.
67
MD |
|
|
|
| |
5 |
| 1 | 2 | 3 | |
4 |
|
|
| 8 | |
REC | 4 | 5 | 6 | ||
| |||||
|
|
|
| ||
3 |
| 7 | 8 | 9 | |
| DISP | ||||
2 | EDIT | NAME 0/10 | >10 9 | ||
ENTER | |||||
MODE |
1 !~ = - 0
1
Press to switch the MD recorder on or off (not possible with all models, especially those without a standby mode).
24÷¢
4: Press to return to the beginning of the current track. Press repeatedly to return to the beginning of previous tracks.
¢ : Press to advance to the beginning of the next track. Press repeatedly to advance to the beginning of following tracks.
31÷Á
1: Hold down for fast reverse playback. Á : Hold down for fast forward playback.
4¦ REC
Press to start recording (may put some decks in REC PAUSE mode).
57
Press to stop playback or recording.
63
Press to start playback.
78
Press to pause playback or recording.
8Number buttons
Use to select tracks.
9>10
You can also use this button when selecting track numbers higher than 10.
00/10
Use to select tracks with high numbers. The button will increase the track number in increments of ten.
-NAME
Use to name tracks or programmed selections.
=EDIT MODE
Allows you to edit names and numbers of tracks.
~DISP
Allows you to change the display mode of the MD.
!ENTER
Enters the changes you have made in the EDIT MODE.
66