Pioneer VSX-39TX Installing the Receiver, Opening the Front Panel, Remote Control Battery Alarm

Before You Start

Remote Control Battery Alarm

When the batteries get too weak to operate the remote control properly an alarm

Change Battery !! OK ?

will sound and a warning screen will appear on the remote. Change the batteries as

shown on the previous page.

SIZE AA, LR6

The Touch Pen & Lock

The touch pen is located in the back right-hand corner of the remote control. Take it out by sliding your finger along the bottom right edge of the remote control and then grasping the pen with thumb and forefinger.

The lock switch is located in the top right-hand corner on the back of the remote control. When this switch is set to LOCK you can’t use the buttons on the remote control. This is helpful to prevent you from mistakenly pushing a button. For normal use keep the switch set in USE.

Remote Control Cushions

lock switch Touch pen

PREPARATION

Apply the cushions to the feet of the remote control as shown in the diagram right.

Operating range of remote control unit

The area in which you can use the remote control to operate the VSX-39TX is fairly large. To use, point the remote control toward the remote sensor on the front panel of this unit while within the range shown right.

Remote control may not function properly if:

•There are obstacles between the remote control and the remote sensor.

•Direct sunlight or fluorescent light is shining onto the remote sensor.

•The receiver located near a device emitting infrared rays.

•Operated simultaneously with another remote control which uses infrared rays.

30

30

23 feet (7m)

Installing the Receiver
Please note:
• Do not place objects directly on top of this unit. This would prevent	8 inches (20 cm)
proper heat dispersal.
• When installing in a rack, shelf, etc., be sure to leave more than 8		Receiver
inches of space above the receiver.

Opening the Front Panel

To open the front panel push gently on the lower third of the panel with your finger.

11