Pioneer VSX-45TX manual DIGITAL-IN Select should be, Selected, if not use the 5∞ buttons

Fine Tuning Your System

Assigning the Digital Inputs

If you did not hook up your digital equipment in accordance with the default settings for the digital inputs (see pages 17,19 & 22–23) you need to complete the procedure below. You have to do this in order to tell the receiver what digital equipment is hooked up to which terminal so the buttons on the remote corre- spond to what you have hooked up.

VCR2 VIDEO	CD	MULTI
		OPERATION

CD-R/	MD/	TUNER	RECEIVER
TAPE1	TAPE2

DIMMER	LOUDNESS	TONE	EFFECT/CH SEL
1	2	3	4
SIGNAL SEL	DNR	BASS/TREBLE	+
5	6	7	8
VIDEO SEL	HI-BIT	+10	– DISC

9 0 ENTER

2		DIRECT ACCESS	SEARCH MODE
	SYSTEM SETUP		GUIDE
	MENU		TOP MENU
	TUNER EDIT		TRACK
		ENTER	EXIT
	AUDIO		RETURN

1

3-8

(If you are continuing from page 89 you can skip the first two steps.)

1Turn on the receiver and your TV, press RECEIVER on the remote control.

MPX	DTV ON/OFF	DISP MODE	2	Press the SYSTEM SETUP button.
¶	8	SUB TITLE
	3-8	2	3	Looking at the on-screen display on
				your TV, use the 5∞ buttons to
				select INPUT ASSIGN. Press the
STANDBY/ON	STANDBY			ENTER button.

MOVIE	MUSIC	ENTER				4	DIGITAL-IN SELECT should be
	MULTI JOG	SET UP	RETURN SELECT HI-SAMPLING	MODE	BAND
		MULTI JOG CONTROL SIGNAL HI-BIT		SB CH			selected, if not use the 5∞ buttons
		PHONES	TONE CONTROL
			SPEAKERS TONE BASS/TREBLE
							to select it. Press the ENTER button.

3	System Setup
	[ 1. Surround Setup					]
	[ 2. THX CINEMA Setup ]
	[	3. Input Assign				]
	[	4. Function Rename				]
	[ 5. PHONO/LINE Setup ]
	[ 6. Multi Room					]
	[ 7. 12V Trigger					]
	[ Exit					]
4	3.Input Assign
	[					]
		Digital-In Select
	[ Component-In Select ]
	[Exit]
5	Digital-In Select
		Digital-1	[ TV/SAT ]
		Digital-2	[	DVD/LD		]
		Digital-3	[		OFF	]
		Digital-4	[		CD	]

[Exit]

memo

•The possible digital inputs that can be assigned are: DVD/LD, TV/SAT, VCR1, VCR2, CD, CD-R, MD.

•If you assign a digital input to a certain function (for example DVD/LD) then any digital inputs pre- viously assigned to that function will automati- cally be set to OFF. This is because one func- tion cannot be assigned to two different places.

5Use the 5∞ buttons to move through the different digital inputs and press the ENTER button.

6Use the 5∞ buttons select the component that you hooked up to that digital in. Press the ENTER

button.

If you're not sure which component is connected to which digital in, look on the back of the receiver and check the cables you connected.

7When you're finished use the 5∞ buttons to select EXIT and press

ENTER.

This exits the DIGITAL-IN SELECT mode.

8Use the 5∞ buttons to select EXIT and press ENTER. Then, use the 5∞ buttons to select EXIT and press

ENTER again.

This exits the SYSTEM SETUP mode and returns to normal operation.

EXPERT

91