Pioneer VSX-45TX manual Specifications

Techno Tidbits & Problem-solving

Specifications

Amplifier Section

Continuous average power output of 100 watts* per channel, min., at 8 ohms, from 20 Hz to 20,000 Hz with no more than 0.09 %** total harmonic distortion (front).

Continuous Power Output
Front	100 W +100 W (20 Hz – 20 kHz, 0.09 %, 8 Ω			)
Center	100 W +100 W (20 Hz – 20 kHz, 0.09 %, 8 Ω			)
Surround	100 W +100 W (20 Hz – 20 kHz, 0.09 %, 8 Ω			)
Surround Back	100 W +100 W (20 Hz – 20 kHz, 0.09 %, 8 Ω )
..................
Input (Sensitivity/Impedance)			4.7 mV/47 kΩ
PHONO MM
VCR 1/DVR, VCR 2, DVD/LD, TV/SAT, VIDEO, CD,
CD-R/TAPE 1, MD/TAPE 2			335 mV/47 kΩ
Frequency Response
PHONO MM	20 Hz to 20,000 Hz ± 0.3 dB
VCR 1/DVR, VCR 2, DVD/LD, TV/SAT, VIDEO, CD,
CD-R/TAPE 1, MD/TAPE 2		5 Hz to 100,000 Hz –+03dB
Output (Level/Impedance)
VCR 1/DVR REC, VCR 2 REC, CD-R/TAPE 1,
MD/TAPE 2 REC		335 mV/2.2 kΩ
Tone Control
BASS		± 6 dB (100 Hz)
TREBLE		± 6 dB (10 kHz)
LOUDNESS		+4/+2 dB (100Hz/10 kHz)
		(at volume position -40dB)
Signal-to-Noise Ratio (IHF, short circuited, A network)
VCR 1/DVR, VCR 2, DVD/LD, TV/SAT, VIDEO, CD,
CD-R/TAPE 1, MD/TAPE 2, MULTI CH IN			.......... 101 dB
Signal-to-Noise Ratio [EIA, at 1 W (1 kHz)]
VCR 1/DVR, VCR 2, DVD/LD, TV/SAT, VIDEO, CD,
CD-R/TAPE 1, MD/TAPE 2			83 dB

*Measured pursuant to the Federal Trade Commission’s Trade Regulation rule on Power Output Claims for Amplifiers.

**Measured by Audio Spectrum Analyzer.

VIDEO Section (S jack)

Input (Sensitivity/Impedance)
VCR 1/DVR, VCR 2, VIDEO, DVD/LD, TV/SAT		Vp-p/75 Ω
Luminance signal (Y)	1
Chrominance signal (C)	0.286	Vp-p/75 Ω
Output (Level/Impedance)
VCR 1/DVR, VCR 2, MONITOR OUT		Vp-p/75 Ω
Luminance signal (Y)	1
Chrominance signal (C)	0.286	Vp-p/75 Ω
Frequency Response
VCR 1/DVR, VCR 2, VIDEO, DVD/LD, TV/SAT		MHz –+03dB
Luminance signal (Y)	5 Hz to 10
Signal-to-Noise Ratio
Luminance signal (Y)		65 dB

Component Video Section
Input (Sensitivity)
Y			1 Vp-p/75 Ω
PB/PR			0.7 V/75 Ω
Output (Level/Impedance)
Y			1 Vp-p/75 Ω
PB/PR			0.7 V/75 Ω
Frequency Response
				+0
Y		5 Hz to 40 MHz		–3 dB
PB/PR		5 Hz to 40 MHz –+03dB
VIDEO Section (Composite)
Input (Sensitivity/Impedance)
VCR 1/DVR, VCR 2, VIDEO, DVD/LD,
TV/SAT			1 Vp-p/75 Ω
Output (Level/Impedance)
VCR 1/DVR, VCR 2, MONITOR OUT,
MONITOR OUT2			1 Vp-p/75 Ω
Frequency Response
VCR 1/DVR, VCR 2, TV/SAT, DVD/LD				+0
VIDEO=MONITOR OUT, ............. 5 Hz to 10 MHz				–3 dB
Signal-to-Noise Ratio			65 dB
FM Tuner Section
Frequency Range		87.5 MHz to 108 MHz
Usable Sensitivity	Mono: 13.2 dBf, IHF (1.3 µV/75 Ω )
50 dB Quieting Sensitivity		Mono: 20.2 dBf
		Stereo: 38.6 dBf
Signal-to-Noise Ratio		Mono: 73 dB (at 85 dBf)
		Stereo: 70 dB (at 85 dBf)
Distortion		Stereo: 0.5 % (1 kHz)
Alternate Channel Selectivity		60 dB (400 kHz)
Stereo Separation		40 dB (1 kHz)
Frequency Response		30 Hz to 15 kHz (± 1) dB
Antenna Input		75 Ω	unbalanced
AM Tuner Section
Frequency Range		530 kHz to 1,700 kHz
Sensitivity (IHF, Loop antenna)			350 µV/m
Selectivity			25 dB
Signal-to-Noise Ratio			50 dB
Antenna		Loop antenna
Miscellaneous
Power Requirements		AC 120 V, 60 Hz
Power Consumption			600 W
Power Consumption in Standby mode			0.8 W
AC Outlet SWITCHED		100 W (0.8 A) MAX
Dimensions	420 (W) ⋅ 188 (H) ⋅		464 (D) mm
(16-9/16 (W) ⋅		7-7/16 (H) ⋅ 18-5/16 (D) in.)
Weight (without package)		18.8 kg (41 lb 8 oz)
Furnished Parts
FM wire Antenna				1
AM loop Antenna				1
“AA” IEC LR6 batteries	..................................................			4
Remote Control Unit				1
Microphone for Auto Surround Sound Setup				1
Microphone Stand for Auto Surround Sound Setup				1
Operating Instructions				1

EXPERT

NOTE:	119
Specifications and the design are subject to possible

modifications without notice, due to improvements.