Pioneer VSX-45TX manual Connecting Satellite TV SAT Components, Satellite tuner

Connecting Your Equipment

Connecting Satellite TV (SAT) Components

Before making or changing the connections, switch off the power and disconnect the power cord from the AC outlet.

Hook up the video signal with either component video, S video, or composite video cords, depending on how you connected the receiver to your TV (see page 16).

For the audio signal, in order to use digital soundtracks broadcast you must hook up a digital input. Use either a coaxial or optical cable, it doesn't matter which (see pages 22–23). We recommend hooking up your audio with analog cables as well (see below).

*The arrows indicate the direction of the TV signal.

										VIDEO
										COMPO-	VIDEO
										NENT	OUT
										Y
										PB	S-VIDEO
ASSIGNABLE					MULTI-ROOM		PRE OUT	ASSIGNABLE
PCM/	FM UNBAL 75Ω		AM LOOP						MONITOR OUT	PR
2DIGITAL /				ANTENNA	& SOURCE			Y
DTS/MPEG					MONITOR OUT
							SUB				Satellite tuner
		CONTROL	MULTI-ROOM
OUT1	IN					CENTER	WOOFER
			& SOURCE
			R OUT	MONITOR				PB	12V
	OUT			L	OUT
OUT2						FRONT			TRIGGER
									(DC OUT12V/	ANALOG	DIGITAL
	R	L				R	L	PR	100mA MAX)
IN 1										AUDIO	DIGITAL
	PLAY
						SUR-
(TV/
SAT)	IN			IN		ROUND		Y	(DVD/LD) IN 1	L
						R	L
IN 2	CD-R/			VCR1/
							(Single)
(CD-R/	TAPE1			DVR		SUR-
TAPE1)	OUT			OUT		ROUND		PB
						BACK				R
	REC					R	L		MULTI-ROOM
IN 3	PLAY					FRONT			& SOURCE
									REMOTE IN
(DVD/	IN			IN				PR
LD)	MD/			VCR2		R	L
IN 4	TAPE2					SUR-
(CD)	OUT			OUT		ROUND		Y
	REC					R	L
	CD			TV/		SUB	CEN-
						WOOF-	TER
	IN			SAT		ER		PB
				IN
	PHONO/			DVD/		SUR-
	LINE					ROUND
USB				LD				PR	RS-232C
	IN					BACK
AUDIO				IN		R	L
	R	L	R	L					(TV/SAT) IN 2
					VIDEO	S VIDEO
DIGITAL		AUDIO	AUDIO		VIDEO		MULTI CH IN	COMPONENT VIDEO

memo • If your component video connections are different from the default settings, you will need to assign them with "Assigning the Component Video Inputs". See page 92 to do

this.

•If your digital connections are different than the default settings you will need to assign the digital jacks to the proper component(s) with the "Assigning the Digital Inputs" procedure. See page 91 to do this.

PREPARATION

19