Controls and displays | 04 |
+/–
Use to adjust the effect and channel levels, as well as to change Dolby Pro Logic IIx and Neo:6 Music parameter settings.
SLEEP (SHIFT &
Use to put the receiver in sleep mode and select the amount of time before the receiver turns off (page 37).
DIALOG E (SHIFT & +)
Use to make dialog stand out when watching TV or a movie (page 36).
10 SHIFT
Press to access the DVR controls (above the component control buttons) as well as some RECEIVER controls.
11 SOURCE
Press to turn on/off other components connected to the receiver (see page 50 for more on this).
12 Character display (LCD)
This display shows information when transmitting control signals.
The following commands are shown when you’re setting the remote to control other components (see Controlling the rest of your system on page 50):
SETUP
Indicates the setup mode, from which you choose the options below.
PRESET
See Selecting preset codes directly on page 50.
LEARN
See Programming signals from other remote controls on page 51.
DIRECT F
See Direct function on page 52.
ERASE
See Erasing one of the remote control button settings on page 52.
RESET
See Erasing all of the remote control presets on page 52.
READ ID
See Confirming preset codes on page 52.
13 RECEIVER
Switches the remote to control the receiver (used to select the green commands above the number buttons (INPUT ATT, etc). Also use this button to set up surround sound (page 11, page 38).
14 VOL +/–
Use to set the listening volume.
15 MUTE
Mutes the sound or restores the sound if it has been muted (adjusting the volume also restores the sound).
Operating range of remote control unit
The remote control may not work properly if:
•There are obstacles between the remote control and the receiver's remote sensor.
•Direct sunlight or fluorescent light is shining onto the remote sensor.
•The receiver is located near a device that is emitting infrared rays.
•The receiver is operated simultaneously with another infrared remote control unit.
30
30
7m
29
En
