09Controlling the rest of your system
Chapter 9:
Controlling the rest of your system
Setting the remote to control other components
Most components can be assigned to one of the MULTI CONTROL buttons using the component’s manufacturer preset code stored in the remote.
However, please note that there are cases where only certain functions may be controllable after assigning the proper preset code, or the codes for the manufacturer in the remote control will not work for the model that you are using.
If you can’t find a preset code that matches the component you want to control, you can still teach the remote individual commands from another remote control (page 51).
Note
•TV codes (for example, codes for TV, CATV, Satellite TV or DTV) can only be assigned to the TV/SAT or TV CONT button.
•If you assign the TUNER function to another component, you will have to reassign it to the Pioneer preset code to use this receiver’s
•You can cancel or exit any of the steps by pressing RECEIVER. To go back a step, press RETURN.
•After one minute of inactivity, the remote automatically exits the operation.
Selecting preset codes directly
RECEIVER | INPUT | SOURCE | |
SELECT | |||
|
|
DVD/LD |
| TV/SAT | DVR/VCR | TV CONT |
|
| MULTI CONTROL |
| |
CD | TUNER | RECEIVER | ||
INPUT ATT | FL DIMMER | SR | ||
| +10 |
| DISC | |
|
|
|
| ENTER |
D.ACCESS |
|
|
| CLASS |
TOP MENU |
|
|
| MENU |
|
| TUNE |
|
|
DTV MENU | ST |
| ST |
|
T.EDIT |
| ENTER | BAND | |
|
|
| ||
SYSTEM | TUNE |
|
| |
GUIDE SETUP |
|
| RETURN |
TV CONTROL
1While pressing the RECEIVER button, press and hold the 1 button.
The remote LCD display shows SETUP.
2Press the MULTI CONTROL button for the component you want to control.
The LCD on the remote displays the component you want to control.
•You can’t assign the RECEIVER button.
3 | Use | (cursor left/right) to select PRESET |
then press ENTER. | ||
4 | Use | (cursor up/down) to select the first |
letter of the brand name of your component then press ENTER.
This should be the manufacturer’s name (for example, P for Pioneer).
5 Use (cursor up/down) to select the manufacturer’s name from the list then press ENTER.
6 Use (cursor up/down) to select the proper code from the list, then try using this remote control with your component.
The code should start with the component type (for example, DVD 009). If there is more than one, start with the first one.
To try out the remote control, switch the component on or off (into standby) by pressing SOURCE . If it doesn’t seem to work, select the next code from the list (if there is one).
•If you can’t find or properly enter a preset code, you can still teach the remote individual commands from another remote control (see Programming signals from other remote controls below).
7If your component is controlled successfully, press ENTER to confirm.
The remote LCD display shows OK.
TVVOL | INPUT | TV CH | VOL |
| SELECT |
|
|
50
En