Pioneer VSX-72TXV-S, VSX-74TXVI, VSX-74TXVi-S Link messages, USB interface, Message Explanation

Additional information 12

i.LINK messages

You may see the following messages displayed in the front panel display when using the i.LINK interface.

Message	Explanation
BUS FULL	The i.LINK bus has reached its capacity and cannot transmit any more data.
CANNOT LINK 1	The connection between the receiver and the selected i.LINK-equipped component is unstable. If the
	i.LINK cables appear to be connected properly and both the receiver and i.LINK-equipped component are
	on, switch both units off, then on again to re-establish the connection between them.
CANNOT LINK 2	The receiver can’t identify the selected i.LINK-equipped component. For example, the receiver may not be
	able to identify an i.LINK-equipped personal computer.
LINK CHECK	The receiver is checking the i.LINK network. It does this when components are added to, or removed from
	the network. The sound may be interrupted if this happens during playback.
LOOP CONNECT	The i.LINK network cannot function because the connected components form a loop. See Creating an
	i.LINK network on page 50 for more on this.
NO NAME	When an i.LINK-equipped component has no name, this message is displayed instead of the proper
	component name.
NO SIGNAL	A component is outputting an i.LINK signal that the receiver cannot reproduce. This receiver can only
	reproduce signals from i.LINK-Audio-equipped components. See About i.LINK on page 50 for more on this.
PQLS OFF	This is displayed on a playback component when PQLS turns off during playback. The sound may be
	interrupted momentarily when this happens.
PQLS ON	This is displayed on a playback component when PQLS turns on during playback. The sound may be
	interrupted momentarily when this happens.
UNKNOWN	When an i.LINK-equipped component name cannot be recognized, this message is displayed instead of
	the proper component name.

USB interface

Symptom	Remedy
No sound.	• Make sure you have set up your computer system to output through the USB interface (see Using the USB
	interface on page 52).
	• Make sure your computers output level is turned up.
	• Update to a more recent version of your software, try a different audio program, or try a different source.

HDMI

Symptom	Remedy
The HDMI indicator blinks	• Check all the points below.
continuously.
No picture or sound.	• This receiver is HDCP-compatible. Check that the components you are connecting are also HDCP-
	compatible. If they are not, please connect them using the component, S-video or composite video jacks.
	• Depending on the connected source component, it’s possible that it will not work with this receiver (even
	if it is HDCP-compatible).
	• If the problem still persists when connecting your HDMI component directly to your monitor, please
	consult the component or monitor manual or contact the manufacturer for support.
No picture.	• If your display device is not SD (480i) compatible then neither the setup screens or the 480i to HDMI
	converted video will be displayed. In this case, connect using the component, S-video or composite video
	jacks.
	• Depending in the output settings of the source component, it may be outputting a video format that can’t
	be displayed. Change the output settings of the source, or connect using the component, S-video or
	composite jacks.

No sound, or sound suddenly ceases.

•Check that the HDMI AV setting is set to AMP/THROUGH.

•If the component is a DVI device, use a separate connection for the audio.

•If analog video is being output over HDMI then there will be no HDMI audio output. Please use a separate connection for the audio.

•Check the audio output settings of the source component.

79

En