04Basic Setup

3Press RECEIVER on the remote control, then press the SETUP button.

An on-screen display (OSD) appears on your TV. Use /// and ENTER on the remote

control to navigate through the screens and select menu items. Press RETURN to exit the current menu.

•Press SETUP at any time to exit the System Setup menu.1

7Confirm the speaker configuration. The configuration shown on-screen should reflect the actual speakers you have.

•With error messages (such as Too much ambient noise) select RETRY after checking for ambient noise (see Other problems when using the Auto MCACC Setup on page 31).

1.Auto MCACC

4Select ‘Auto MCACC’ from the System Setup menu then press ENTER.2

System Setup

1.Auto MCACC 2.Manual SP Setup 3.Input Assign 4.Pre Out Setting

Return

Try to be as quiet as possible after pressing ENTER. The system outputs a series of test tones to establish the ambient noise level.

5Follow the instructions on-screen.

•Make sure the microphone is connected.

•Make sure the subwoofer is on and the volume is turned up.

•See below for notes regarding background noise and other possible interference.

6Wait for the test tones to finish.

A progress report is displayed on-screen while the receiver outputs test tones to determine the speakers present in your setup. Try to be as quiet as possible while it’s doing this.

1.Auto MCACC

Now Analyzing

Environment Check

Ambient Noise

Speaker YES/NO

Return

Check!

Front

[

YES ]

Center

[

YES ]

Surr

[

YES ]

Surr. Back

[YESx2]

Subwoofer

[

YES ]

 

 

 

 

 

10:Next

 

 

OK

 

 

Return

If the speaker configuration displayed isn’t correct, use / to select the speaker and / to change the setting. When you’re finished, go to the next step.

If you see an error message (ERR) in the right side column, there may be a problem with the speaker connection. If selecting RETRY doesn’t fix the problem, turn off the power and check the speaker connections.

8Make sure ‘OK’ is selected, then press

ENTER.

If the screen in step 7 is left untouched for 10 seconds and the ENTER button is not pressed in step 8, the Auto MCACC setup will start automatically as shown below.

A progress report is displayed on-screen while the receiver outputs more test tones to determine the optimum receiver settings for channel level, speaker distance, and Acoustic Calibration EQ.

1.Auto MCACC

Now Analyzing

Surround Analyzing

Speaker System

Speaker Distance

Channel Level

Acoustic Cal EQ

•For correct speaker settings, do not adjust the volume during the test tones.

Return

Note

1The screensaver automatically starts after three minutes of inactivity. If you cancel the Auto MCACC Setup at any time, the receiver automatically exits and no settings will be made.

2MIC IN blinks when the microphone is not connected to MCACC SETUP MIC.

30

En