11Additional information

Resetting the main unit

Use this procedure to reset all the receiver’s settings to the factory default. Use the front panel controls to do this.

1Switch the receiver into standby.

2While holding down the BAND button, press and hold the STANDBY/ON button for about two seconds.

3When you see RESET? appear in the display, press AUTO/DIRECT.

OK? shows in the display.

4Press STEREO/ALC to confirm.

OK appears in the display to indicate that the receiver has been reset to the factory default settings.

Specifications

Amplifier section

Continuous average power output of 80 watts* per channel, min., at 8 ohms, from 20 Hz to 20 000 Hz with no more than 0.08 %** total harmonic distortion.

Front (stereo). . . . . . . . . . . . . . . . 80 W + 80 W Power output (1 kHz, 8 Ω, 0.05 %)

. . . . . . . . . . . . . . . . . . . . . . . . .110 W per channel Guaranteed speaker impedance

FRONT:A, B . . . . . . . . . . . . . . . . . . . 6 Ω to 16 Ω FRONT:A+B . . . . . . . . . . . . . . . . . 12 Ω to 16 Ω SURROUND, CENTER . . . . . . . . . . 6 Ω to 16 Ω

*Measured pursuant to the Federal Trade Commission’s Trade Regulation rule on Power Output Claims for Amplifiers

**Measured by Audio Spectrum Analyzer

Audio Section

Input (Sensitivity/Impedance)

LINE . . . . . . . . . . . . . . . . . . . . . . . 200 mV/47 kΩ Output (Level/Impedance)

REC OUTPUT. . . . . . . . . . . . . . . 200 mV/2.2 kΩ Signal-to-Noise Ratio

(IHF, short circuited, A network)

LINE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 98 dB

74

Signal-to-Noise Ratio [EIA, at 1 W (1 kHz)] LINE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 79 dB

Tuner Section

Frequency Range (FM) . . . 87.5 MHz to 108 MHz Antenna Input (FM) . . . . . . . . . .75 Ω unbalanced Frequency Range (AM) . . . . 530 kHz to 1700 kHz Antenna (AM). . . . . . . . . . . . . . . . . .Loop antenna

Video Section

Signal level

Composite . . . . . . . . . . . . . . . . . . 1 Vp-p (75 Ω) Component Video . . . . . . . . . Y: 1.0 Vp-p (75 Ω)

PB, PR: 0.7 Vp-p (75 Ω)

Corresponding maximum resolution Component Video . . 1080i (1125i)/720p (750p)

Digital In/Out Section

HDMI terminal . . . . . . . . . . . . . . . .Type A (19-pin) HDMI output type . . . . . . . . . . . . . . . 5 V, 100 mA USB terminal . . . . . . USB2.0 Full Speed (Type A) iPod terminal . . . . . USB, and Video (Composite) SIRIUS antenna cable . . . . . 8-pin mini DIN cable

Miscellaneous

Power Requirements. . . . . . . . . . AC 120 V, 60 Hz Power Consumption . . . . . . . . . . . . . . . . . . 245 W In standby. . . . . . . . . . . . . . . . . . . . . . . . . 0.4 W

Dimensions

. . . . . 420 mm (W) x 158 mm (H) x 347.7 mm (D)

169/16 in. (W) x 61/4 in. (H) x 133/4 in. (D) Weight (without package). . . . . 9 kg (19 lb 14 oz)

Furnished Parts

Microphone (for Auto MCACC setup) . . . . . . . . 1 Remote control . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Dry cell batteries (AAA size IEC R03) . . . . . . . 2 AM loop antenna . . . . . . . . . . . . . . . . . . . . . . . . . 1 FM wire antenna . . . . . . . . . . . . . . . . . . . . . . . . . 1 iPod cable. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 These operating instructions

Note

•Specifications and the design are subject to possible modifications without notice, due to improvements.

En