Additional information | 11 |
Problem | Remedy |
No sound from surround or | • Connect the speakers properly (refer to page 18). |
center speakers. | • Refer to Speaker Setting on page 43 to check the speaker settings. |
| • Refer to Channel Level on page 45 to check the speaker levels. |
|
|
The PHASE CONTROL | • If applicable, check that the lowpass filter switch on your subwoofer is |
feature doesn’t seem to | off, or the lowpass cutoff is set to the highest frequency setting. If there is |
have an audible effect. | a PHASE setting on your subwoofer, set it to 0º (or depending on the |
| subwoofer, the setting where you think it has the best overall effect on the |
| sound). |
| • Make sure the speaker distance setting is correct for all speakers (see |
| Speaker Distance on page 46). |
|
|
Considerable noise in radio | • Connect the antenna (page 27) and adjust the position for best |
broadcasts. | reception. |
| • Route any loose cables away from the antenna terminals and wires. |
| • Fully extend the FM wire antenna, position for best reception, and |
| secure to a wall (or connect an outdoor FM antenna). |
| • Connect an additional internal or external AM antenna (page 27). |
| • Turn off equipment causing interference or move it away from the |
| receiver (or move antennas farther away from equipment causing noise). |
|
|
Broadcast stations cannot | • Connect an outdoor antenna (refer to page 27). |
be selected automatically. |
|
|
|
Noise during playback of a | • Move the cassette deck away from your receiver, until the noise |
cassette deck. | disappears. |
|
|
Sound is produced from | • Set the SIGNAL SEL to HDMI, C1/O1/O2 (DIGITAL) or A (analog) |
other components, but not | according to the type of connections made (refer to page 41). |
from LD or DVD player. | • Set the digital input settings correctly (refer to page 46). |
| • Make digital connections (refer to page 23) and set the SIGNAL SEL to |
| C1/O1/O2 (DIGITAL) (refer to page 41). |
| • Refer to the instruction manual supplied with the DVD player. |
|
|
No sound is output or a | • Set the digital volume level of the player to full, or to the neutral |
noise is output when | position. |
software with DTS is played | • Make sure the player’s settings are correct and/or the DTS signal out is |
back. | on. Refer to the instruction manual supplied with the DVD player. |
| • Set the input signal type to C1/O1/O2 (DIGITAL) (see Choosing the |
| input signal on page 41). |
|
|
During a playback search, | • This is not a malfunction, but be sure to turn the volume down to |
noise is output from a DTS | prevent the output of loud noise from your speakers. |
compatible CD player. |
|
|
|
Everything seems to be set | • Check that the positive/negative speaker terminals on the receiver are |
up correctly, but the | matched with the corresponding terminals on the speakers (see |
playback sound is odd. | Connecting the speakers on page 18). |
|
|
Español Nederlands Italiano Français Deutsch English
69
En