Other connections
CAUTION
•Before making or changing the connections, switch off the power and disconnect the power cord from the power outlet. Plugging in components should be the last connection you make with your system.
•Do not allow any contact between speaker wires from different terminals.
Connecting an iPodThis receiver has a dedicated iPod terminal that will allow you to control playback of audio content from your iPod using the controls of this receiver.1
•Push down on the PUSH OPEN tab to access the iPod terminal.
CONTROL ON/OFF
MASTER
VOLUME
VIDEO INPUT
iPod iPhone
USB |
| MCACC |
VIDEO | L AUDIO R | SETUP MIC |
This receiver
Music
Genius >
Playlists
iPod cableArtists
Albums
Songs
Radio
Genres
Composers
Audiobooks
MENU
iPod
1 Set this receiver to the standby mode, and then use the iPod cable to connect your iPod to the iPod terminal on the front panel of this receiver.
For the cable connection, refer to also the operating instructions for iPod.
2 Switch the receiver on and press the iPod USB input source button to switch the receiver to the iPod.
The front panel display shows Loading while the receiver verifies the connection and retrieves data from the iPod.
Note
1• This system is compatible with the audio and the video of the iPod nano, iPod (fifth generation), iPod classic, iPod touch and iPhone (iPod shuffle not supported). However, that some of the functions may be restricted for some models. Note, however, compatibility may vary depending on the software version of your iPod and iPhone. Please be sure to use the latest available software version.
•iPod and iPhone are licensed for reproduction of
•Features such as the equalizer cannot be controlled using this receiver, and we recommend switching the equalizer off before connecting.
•Pioneer cannot under any circumstances accept responsibility for any direct or indirect loss arising from any inconvenience or loss of recorded material resulting from the iPod failure.
58
En