Pioneer VSX-84TXSI, VSX-82TXS-S, VSX-84TXSi-S Link messages, USB interface, Message Explanation

12Additional information

Symptom

The program format indicators don’t disappear when SACD playback stops.

Remedy

• The program format indicators remain lit until another format source is input. This is not a malfunction.

You can’t get i.LINK to display	• Make sure your i.LINK source components are switched on.
when using the SIGNAL SELECT	• Check that i.LINK is assigned correctly (see The Input Setup menu on page 63).
button.
After upgrading a component, it	• You may need to reset the i.LINK database memory in the receiver (use the front panel):
is not recognized and cannot be	With the receiver in standby, press STANDBY/ON while holding down RETURN. When you see DB
selected using the i.LINK	CLEAR? appear in the display, press ENTER, then SETUP again to confirm. When you’ve reset the i.LINK
connection.	database memory, DB CLEAR SET shows in the display. If DB ERROR is displayed, step through the
	procedure again.

i.LINK messages

You may see the following messages displayed in the front panel display when using the i.LINK interface.

Message	Explanation
BUS FULL	The i.LINK bus has reached its capacity and cannot transmit any more data.
CANNOT LINK 1	The connection between the receiver and the selected i.LINK-equipped component is unstable. If the
	i.LINK cables appear to be connected properly and both the receiver and i.LINK-equipped component are
	on, switch both units off, then on again to re-establish the connection between them.
CANNOT LINK 2	The receiver can’t identify the selected i.LINK-equipped component. For example, the receiver may not be
	able to identify an i.LINK-equipped personal computer.
LINK CHECK	The receiver is checking the i.LINK network. It does this when components are added to, or removed from
	the network. The sound may be interrupted if this happens during playback.
LOOP CONNECT	The i.LINK network cannot function because the connected components form a loop. See Creating an
	i.LINK network on page 53 for more on this.
NO NAME	When an i.LINK-equipped component has no name, this message is displayed instead of the proper
	component name.
NO SIGNAL	A component is outputting an i.LINK signal that the receiver cannot reproduce. This receiver can only
	reproduce signals from i.LINK-Audio-equipped components. See About i.LINK on page 52 for more on this.
PQLS OFF	This is displayed on a playback component when PQLS turns off during playback. The sound may be
	interrupted momentarily when this happens.
PQLS ON	This is displayed on a playback component when PQLS turns on during playback. The sound may be
	interrupted momentarily when this happens.
UNKNOWN	When an i.LINK-equipped component name cannot be recognized, this message is displayed instead of
	the proper component name.

USB interface

Symptom	Remedy
No sound.	• Make sure you have set up your computer system to output through the USB interface (see Using the USB
	interface on page 54).
	• Make sure your computers output level is turned up.
	• Update to a more recent version of your software, try a different audio program, or try a different source.

HDMI

Symptom	Remedy
The HDMI indicator blinks	• Check all the points below.
continuously.
No picture or sound.	• This receiver is HDCP-compatible. Check that the components you are connecting are also HDCP-
	compatible. If they are not, please connect them using the component, S-video or composite video jacks.
	• Depending on the connected source component, it’s possible that it will not work with this receiver (even
	if it is HDCP-compatible).
	• If the problem still persists when connecting your HDMI component directly to your monitor, please
	consult the component or monitor manual or contact the manufacturer for support.

82

En