2.1Hardware Connection
1.Locate an optimum location for the WNRT-620. The best place for your WNRT-620 is usually at the center of your wireless network, with line of sight to all of your mobile stations.
2.Adjust the antennas of WNRT-620.Try to adjust them to a position that can best cover your wireless network. The antenna’s position will enhance the receiving sensitivity.
3.Connect RJ-45 cable to WNRT-620 LAN port. Connect one of the LAN ports on WNRT-620 to your LAN switch/hub or a computer with a RJ-45 cable.
4.Connect RJ-45 cable to WNRT-620 WAN port. Connect xDSL/Cable Modem to the WAN port on WNRT-620. Usually, this cable would be provided with your modem. If no cable was supplied with your modem, please use a RJ-45 Ethernet cable
5.Plug in power adapter and connect to power source. After power on, WNRT-620 will start to operate.
Note:
1.ONLY use the power adapter supplied with the WNRT-620. Otherwise, the product may be damaged.
2.If you want to reset WNRT-620 to default settings, press and hold the RST(reset) button over 30 seconds and release. And then wait for WNRT-620 restart.
RST / WPS Button This button has two functions:
To Clear All Data and restore the factory default values:
Press the RST (reset) button for longer than 30 seconds until the LED of power flash, and then the router will reset itself to the factory default settings. (warning: your original configurations will be replaced with the factory default settings)
To make Wi-Fi Protected Setup (WPS) simple and easier:
Press the WPS button (for less than 20 seconds), machine will start WPS function to build connection between wireless network clients and this wireless router.
- 6 -
