3 Pressaor bto adjust the output level
of the subwoofer.
Each press of aor bincreases or decreases
the level of the subwoofer.+6 6is displayed
as the level is increased or decreased.
Using non fading output
When the non fading output setting is on, the
audio signal does not pass through this units
low pass filter (for the subwoofer), but isout-
put through the RCA output.
1 PressAUDIO to select non fading out-
put on/off setting.
PressAUDIO until NOFAD:ON appears in the
display.
#Whenthe subwoofer controller settingis only
P/O:FUL, you can switch to the non fading out-
puton/off setting.(Refer to page 41.)
2 Pressato turn non fading output on.
NOFAD:ONappears in the display.Non fading
output is now on.
#Toturn non fading output off, press b.

Adjusting non fading output level

When the non fading output is on, you can ad-
just the level of non fading output.
1 PressAUDIO to select non fading out-
put setting.
PressAUDIO until NOFAD: 0 appears in the
display.
2 Pressaor bto adjust the output level
of the non fading.
Each press of aor bincreases or decreases
the level of the non fading. +6 6is displayed
as the level is increased or decreased.
Using the high pass filter
When you do not want low sounds from the
subwoofer output frequency range to play
from the front or rear speakers, turn the HPF
(high pass filter) on. Only frequencies higher
than those in the selected range are output
from the front or rear speakers.
1 PressAUDIO to select HPF.
PressAUDIO until HPF appears in the display.
2 Pressato turn high pass filter on.
HPF: 80appears in the display. High pass fil-
ter is now on.
#If the high pass filter has been previously ad-
justed,the frequency of that previously selected
willbe displayedinstead of HPF: 80.
#Toturn high pass filter off, press b.
3 Presscor dto select cut-off frequency.
Each press of cor dselects cut-off frequen-
cies in the following order:
5080125 (Hz)
Only frequencies higher than those in the se-
lected range are output from the front or rear
speakers.
Note
If you switch the SFEQ setting, the HPF function
isautomatically turned off. By turning the HPF
functionon af ter selecting the SFEQ setting, you
cancombine HPF functionwith SFEQ
function.
Adjusting source levels
SLA (source level adjustment) lets you adjust
the volume level of each source to prevent ra-
dical changes in volume when switching be-
tween sources.
!Settings are based on the FM tuner volume
level, which remains unchanged.
Audio Adjustments
En
38
Section
08