TM
CHAP. 3
OPERA…
HEXADECIMAL DUMP MODE
“ON LINE” + “POWER ON” (Turn the power on while holding the “ON LINE” switch depressed)
Each of the signals sent from the computer to the printer will be printed out in hexadecimal code. This function allows you to check if a control code sent to the printer by the program being used is correct or not. The buzzer will sound once to indicate the printer is in hexadecimal dump mode. After the program has been run, the last line buffer should be flushed by pressing the “ON LINE” switch. To turn off the mode, it is necessary to turn off the printer completely.
CLEAR PRINT BUFFER
“FEED” + “ON LINE” + “POWER ON” (Turn the power on while holding both the “FEED” and “ON LINE” switches depressed)
This operation clears the printer buffer (The buzzer gives two short beeps). When the printer power is shut off, the data content could degenerate and become unusable. For this reason, when the printer power is turned off and there are some
MICRO FEED
“ON LINE” + “FEED” (Press the “FEED” switch while holding the “ON LINE” switch depressed when the printer is “OFF LINE”)
As a result of this mode, the paper will feed in very small increments.
VALIDATION PRINTING
This printer can print one line of validation printing as described below.
3 - 4