Maintenance
Before doing maintenance on the machine, disconnect it from the electrical supply by pulling out the plug or switching off the main switch! Failure to comply may cause serious injury.
Clean the band saw regularly to remove any resinous deposits and sawdust.
Keep the miter slot, and the guide bearings, clean and free of resin.
Keep the blade clean and sharp. Check it periodically for cracks or other signs of wear.
The drive belt should be checked periodically. If it looks worn, frayed, glazed or otherwise damaged, replace it.
Remove any deposits from the band wheels to avoid vibration and potential blade breakage.
Vacuum or blow out dust from inside the cabinet. (Use proper dust mask equipment).
The table surface must be kept clean and free of rust for best results. If rust appears, you can use a mixture of household ammonia, good commercial detergent and #000 steel wool. Alternatively, commercial rust removers can be found at many hardware stores.
Apply a light coat of paste wax to the table. There are also products in aerosol form available in major hardware stores and supply catalogs. Whatever method is chosen, the coating should protect the metal and provide a smooth surface, without staining workpieces.
If the power cord is worn, cut, or damaged in any way, have it replaced immediately.
Lubrication Points:
Periodically apply a light,
Grease the sliding surfaces of the table trunnions (Figure 50). Also grease the contact area of the trunnion scale and handwheel gear (Figure 50) and the other gears connected to the handwheel (Figure 51).
Grease the blade tension screw (Figure 52).
Oil any pins, shafts, and joints. Do not get oil on the pulleys or belts.
Note: Bearings on the band saw are sealed for life and do not require lubrication.
Figure 49
Figure 50
Figure 51
Figure 52
28
