1.Carefully inspect the outer packaging for evidence of damage during transit.
CAUTION:
Do not install a damaged cabinet. Report any damage to the carrier and contact your local sales or service office immediately.
2.Use a forklift or other material handling equipment to move the cabinet to a convenient unpacking area. Insert the forklift forks between the pallet supports on the bottom of the unit.
CAUTION:
Do not tilt cabinets more than ±10 degrees from vertical.
3.Set each cabinet on a firm, level surface, allowing a minimum clearance of 3 m (10 ft) on each side for removing the cabinets from the pallets.
4. Remove accessory installation kit located at the top of the unit (see figure 1.1) by opening top of outer box.
CAUTION:
If accessory kit is not moved, box will be top heavy upon removal. Approximate weight of accessory kit is 25 lbs. (11 kg.)
5.Remove the protective covering from the cabinets.
6.Remove the packing material, and discard or recycle them in a responsible manner.
7.After removing the protective covering, inspect the contents for any evidence of physical damage, and compare each item with the Bill of Lading. If damage has occurred or shortages are evident, contact the Powerware Customer Service Department immediately to determine the extent of the damage and its impact upon further installation.
NOTE: While awaiting installation, protect the unpacked UPS cabinet from moisture, dust, and other harmful contaminants. Failure to store and protect the UPS properly may invalidate the warranty.
Powerware 9335 (80 kVA and 120 kVA) Installation and Operation | |
| 164201396 REV A 071103 |
