C O M M E R C I A L P R O D U C T S D I V I S I O N
Diagram 14 | Secure the |
| fasteners and |
| replace the |
| hood. |
Alternately tighten four side upright screws.
Alternately tighten the four front panel screws.
Alternately tighten the four screws that secure the display console.
12.Replace the hood. Diagram 14. Reposition the hood on the treadmill and replace the four buttonhead screws removed in step 4.The two screws with washers are placed through the front panel.Tighten the screws using the
13.Tighten all mounting screws with the hex keys provided. Diagram 14. Start at the front of the treadmill with the four screws that attach the upright supports to the front panel. Tightening these screws first helps pull the rest of the treadmill’s parts into alignment.Then, proceed with tightening the four screws
(D) that secure the upright supports, the four console assembly screws (A), the handrail assembly screws (A) and (C), and the hood screws.
Diagram 15 | Adjust the level |
| of the treadmill. |
| Bubble level |
| Running belt |
| Adjustable rear |
| foot |
14.Level the unit. Diagram 15.The C956 or C954 has adjustable rear feet. Check to make sure that the running surface is level (use a bubble level as shown in Diagram 15). If the treadmill is placed on a slightly, uneven surface, adjusting the rear feet can help, but will not compensate for extremely uneven surfaces.
Important: If you need to make adjustments, adjust one rear foot at a time. Do not use the rear foot to raise or lower the unit more than
page 17
