Premier Mounts EST150 installation instructions Multiple Mounting Point Installation Step

EST150

Multiple Mounting Point Installation

Step 1

1) Locate the projector’s mounting points.

2)Position the mounting legs on the projector.

The mounting legs are pre-installed. Depending on the requirements of your projector, you may remove one of the mounting legs.

The number and placement of mounting points on projectors varies between projector manufacturers. Refer to you projector’s technical specifications for the number and location of the mounting points on your specific projector.

Mount carriage not shown.

Step 2

1) Attach the mounting legs to the projector using the corresponding mounting hardware.

Do not tighten the mounting hardware at this time.

Screws shown for illustration purposes only.

Step 3

1)If the mounting legs need to be leveled, rotate the leveling barrels to level the mounting bracket.

2)To raise the mounting legs, rotate the leveling barrel clock-wise. To lower the mounting leg, rotate the leveling barrel counter clock-wise.

Raise or lower each of the mounting legs, by rotating the leveling barrels, until all of the mounting legs are at an equal height.

•Lower the mounting leg by rotating the leveling barrel counter-clockwise.

•Raise the mounting legs by rotating the leveling barrel clockwise.

3)When the desired position is achieved, tighten the mounting screws to the projector and then tighten the hex head leg screws with the M5 Allen wrench.

Page 10 Visit the Premier Mounts website at http://www.premiermounts.com Installation Instructions