Tsunami MP.11and MP.11a Installation and Management
SWITCHING ON THE MP.11/a
The MP.11/a can be powered by a power supply or by Active Ethernet through an Active Ethernet splitter. Depending upon the powering method, you can switch the MP.11/a on by:
▪Plugging the power cord of the power supply into an AC power outlet
▪Connecting the Active Ethernet splitter to the Ethernet cabling
When the power is switched on, the MP.11/a performs startup diagnostics. When startup is completed, the LEDs show the operational state of the MP.11/a (see the following figure).
Power
Ethernet Link
Wireless Link
The following table shows the status of the four LEDs when the MP.11/a is operational (the fourth LED is unused).
Power
OFF |
| Power is not present or is malfunctioning. |
|
|
|
GREEN |
| Power is present; the unit is operational. |
|
|
|
AMBER |
| The unit is initializing after reboot (less than two minutes); it cannot get a dynamic IP |
|
| address or is in Forced Reload state when Ethernet LED also is amber.* |
|
|
|
RED |
| A fatal error in the unit. |
|
|
|
Ethernet Link |
|
|
|
|
|
OFF |
| Not connected. |
|
|
|
GREEN |
| Connected at 10 Mbps. |
|
|
|
BLINKING GREEN |
| Data is being sent. |
|
|
|
AMBER |
| Connected at 100 Mbps, in Forced Reload state when Power LED also is amber*, or |
|
| the unit is initializing after reboot (less than two minutes). |
|
|
|
BLINKING AMBER |
| Data is being sent. |
|
|
|
RED |
| An error in data transfer. |
|
|
|
Wireless Link |
|
|
|
|
|
OFF |
| Wireless interface is up properly but no wireless link established. |
|
|
|
GREEN |
| Immediately after connecting a wireless link. |
|
|
|
BLINKING GREEN |
| Data is being sent or the wireless interface is initializing after reboot (less |
|
| than two minutes). |
|
|
|
RED |
| There is a fatal error on the wireless interface. |
* See “Forced Reload” on page 106.
Chapter 2. Installation | 15 |
CPN 65755 | Issue Date: August 2003 |