Proxim CPN 65755B manual Snmp Parameters, Security Parameters

Tsunami MP.11and MP.11a Installation and Management

			SNMP PARAMETERS
		Set Read and Read/Write Passwords
snmp	R		SNMP Group
snmpipsccesstbl	RW		SNMP IP Access Table
index	R		Index
ipaddr	RW		IP address
submask	RW		Subnet mask
if	RW		Interface [1=Ethernet, 2=PC Card A, 3=PC Card B]
cmt	RW		Comment
status	RW		Status of table entry [1=enable, 2=disable, 3=delete]
snmptraphosttbl	RW		SNMP Trap Host Table
index	R		Index
ipaddr	RW		IP address
passwd	W		Password
cmt	RW		Comment
status	RW		Status of table entry [1=enable, 2=disable, 3=delete]
snmprpasswd	W		Read password
snmprwpasswd	W		Read/write password

Example: This command adds and enables a new entry to the SNMP IP Access Table with IP address 10.0.0.2, subnet mask 255.255.255.0 on an Ethernet interface.

set snmpipaccesstbl 0 ipaddr 10.0.0.2 submask 255.255.255.0 if 1 status 1

		SECURITY PARAMETERS
		MP.11/a Security Settings
security	R	Security Configuration Group
secconfig	RW	Security configuration
secenckeylentbl	RW	Encryption Key Length Table
index	R	Index
enckeylen	RW	Encryption Key Length
SPANNING TREE PARAMETERS (Bridge mode only)
		Help prevent network loops
stp	R	Spanning Tree Group
stptbl	RW	Spanning Tree Table
index	R	Index
priority	RW	Bridge priority
pathcost	RW	Path cost
status	RW	Status of table entry [1=enable, 2=disable]
stpstatus	RW	Spanning Tree status [1=enable, 2=disable]
stppriority	RW	Bridge priority
stpmaxage	RW	Maximum age
stpbridgehellotime	W	Hello time
stpfwddelay	RW	Forward delay

Chapter 6. Command Line Interface	92
CPN 65755	Issue Date: August 2003