Tsunami MP.11and MP.11a Installation and Management
Chapter 4. Basic Management This chapter describes the initial setup of the MP.11/a, which lets you set up and monitor the basic
features of the MP.11/a. In most cases, setting up these basic features is sufficient.
A full overview of the Web Interface is provided in “Chapter 5. Web Interface” on page 42; “Glossary” on
page 118 provides a brief explanation of the terms used.
For CLI commands you can use for basic management, see “Command Line Interface“ on page 79.
The following topics are discussed in this chapter:
▪ Rebooting and Resetting on page 28
▪ General Settings on page 29
▪ Monitoring Settings on page 38
▪ Security Settings on page 40
▪ Upgrading the MP.11 on page 41
To use the Web Interface for configuration and management, you must access the MP.11/a. With
ScanTool you can determine the unit’s current IP address. Then enter http://<ip address> in your Web
browser. See “Chapter 3. Management Overview” on page 19 for details.
The Web Interface consists of Web page buttons and tabs. A tab can also contain sub-tabs. The
following figure shows the convention used to guide you to the correct tab or sub-tab.
The Web Interface also provides online help, which is stored on your computer (see “Installing
Documentation and Software” on page 15 for details). Launch help by clicking the question mark button
in the Web Interface.
Chapter 4. Basic Management 27
CPN 65755 Issue Date: August 2003