Quick Start
Starting a Telnet Session
At the Twin Client main menu on the terminal, press any key to establish the connection. Until the terminal has been authorized, the following screen is displayed.
RECOVERABLE ERROR
Terminal not
Authorized for
Twin Client
Keypress to Continue
It is not necessary to authorize the terminal at this time, so press any key to continue. The terminal will establish a connection with the host system and start emulation. If the terminal fails to connect to the host, refer to the following tables.
Failure Cause | Corrective Action |
Incorrect Host IP address | Correct the Host List address on the terminal. Refer to |
| Terminal Setup Using Twin Client Menus. |
Incorrect netmask value | Access the Edit Functions menu. Correct the netmask |
| value. Refer to Terminal Setup Using Twin Client Menus. |
Error Indication | Possible Cause |
NOT Associated | Invalid NETID |
No AirLoad | AirLoad Manager not |
Manager Found. | active, or not installed |
| on the LAN segment. |
Manager not Active | Previously identified |
| AirLoad Manager is no |
| longer found. |
Unable to open | IP stack on terminal |
connection | failed to load. |
Timeout waiting for | Transient |
data | communications |
| failure |
Download aborted | Socket closed during |
| download |
Manager inactive | PC not operating |
Corrective Action
Run current radio setup program and set NETID to match the access point. See Terminal Setup Using Twin Client Menus.
Ensure that the PC with Twin Client Manager is on the same segment and that the PC is operating. If the PC is not on the same segment, enter the address of the PC in response to the terminal prompt.
Same as above
Reload Program Files and reboot.
Reboot terminal. If problem persists, check the RFSYNC.log in the PowerNetTN directory.
Ensure that PC is operating. Reboot terminal and retry.
Restart the Airload PC server.
After a Telnet session has been successfully established, the terminal will remain in session for a maximum of 30 minutes at a time until it has been authorized. Once authorized, there is no software restriction on the session time. The instructions for authorizing the terminal are presented in Authorizing PowerNet.
Supported Equipment Manual • May, 2006 |
