Command mnemonics
Command mnemonics consist of
Arguments
(1)Arguments are placed in front of the command.
If a command requiring an argument has no argument, an error is generated.
(2)Arguments are of the following types:
1.Address:
The address consists of ASCII digit characters for the frame number and time code, according to the address mode.
The address mode is determined by the FR and TM commands.
If a value greater than the maximum value is attributed, the command will not work normally.
2.Argument:
The argument expresses a parameter for commands with arguments other than the address (KL, GP, DS, etc.).
The argument consists of ASCII alphabetic coded characters and digit characters.
Setting the extend terminal button functions
“Extend Terminal” refers to the function for controlling this unit by turning the switch of a device connected to the EXT TERMINAL connector on the main unit’s rear panel on and off.
•SW1 to SW8 on the EXT TERMINAL connector on the main unit’s rear panel are pulled up to +3.3 V. Assign functions to combinations of SW1 to SW8.
•For the pin layout, see page 64.
•A maximum of 56 switches can be connected by combining SW1 to SW8.
•For the switch combinations and functions assigned upon purchase, see page 69.
1Display the Setup screen. Press the SETUP button.
2Select Initial Settings Options Extend
Terminal User.
Use the /// buttons to select, then press the ENTER button.
|
|
| Initial Settings |
|
|
Currrent |
|
|
|
| |
|
|
|
| ||
01. | | LIST01 | LIST11 | PLAY |
|
02. | | LIST02 | LIST12 | PAUSE |
|
03. | | LIST03 | LIST13 | STOP |
|
04. | | LIST04 | LIST14 | STEP FWD |
|
05. ENTER | LIST05 | LIST15 | STEP REV |
| |
06. LIST01 | LIST06 | LIST16 | SCAN FWD |
| |
07. LIST02 | LIST07 | LIST17 | SCAN REV |
| |
08. | LIST03 | LIST08 | LIST18 | NEXT |
|
09. LIST04 | LIST09 | LIST19 | PREV |
| |
10. | LIST05 | LIST10 | LIST20 | DISPLAY |
|
|
|
|
|
|
|
09
English
67
En