PYLE Audio HD-V9000 48

06 About the external synchronizing function

	ON		ON		ON
	75		75		75
	OFF		OFF		OFF
	EXT SYNC IN		EXT SYNC IN		EXT SYNC IN	Sync generator
	HD-V9000		HD-V9000		HD-V9000
ON	Terminal	OFF	2nd unit	OFF	1st unit

With this unit, the video output signal can be synchronized with NTSC/PAL signals or HD tri-level synchronizing signals (external synchronizing signals) (External Sync function). This makes it possible to set the timing without connecting a TBC (time base corrector) or other such device, so the picture can be switched without being disturbed.

•To use the external synchronizing function, set External Sync to On and set the input signal format, Scaler Setting (output resolution) and the synchronizing input signal format to the same setting (page 46).

•When using the external sync function, use one of the following formats:

720 x 480/59.94i, 720 x 576/50i, 1280 x 720/50p, 1280 x 720/59.94p, 1920 x 1080/50i, 1920 x 1080/59.94i

•The refresh rate output when this unit is started up is set by the TV SYSTEM switch (page 26). To use the external synchronizing function, be sure the external synchronizing signal’s refresh rate and this setting are the same.

•The external sync function does not work if Memory 1, Memory 2 or Memory 3 is selected at Video Settings. Select Default when using the picture quality adjustment function (page 45).

•The VIDEO OUT terminal has a fixed NTSC or PAL output. The external sync function cannot be used with this terminal.

•When the external synchronizing function is activated, S.LOCK is displayed at the upper right of the main unit display.

H D M I : O F F	S	. L O C	K
1 9 2 0 x 1 0 8 0 / 5		9 . 9 4	i

To synchronize one player

Set the 75 Ω (terminating switch) on this unit’s rear panel to ON.

To synchronize two or more players with a sync generator

Set the terminal player’s 75 Ω (terminating switch) to ON, the 75 Ω (terminating switches) of the other players to OFF.

•When two or more players are synchronized and the power of one or more of the players is turned from off to on, the output picture of the other players will be disturbed.

Caution

•Does not lock to the external synchronizing signal’s subcarrier component.

•The picture output from the VIDEO OUT, COMPONENT VIDEO OUT and HDMI OUT terminals will be disturbed for about 30 seconds until locking to the external synchronizing signal.

•Input the external synchronizing signal before playing. Synchronizing is not possible if the signal is input after playback starts. Also, the picture may be disturbed if the external synchronizing signal is interrupted during playback.

•Be sure to set 75 Ω (the terminating switch) to ON before inputting the external synchronizing signal. If an excessive external synchronizing signal is input, the external synchronizing function may become unstable.

•For stable operation of the external synchronizing function, turn the power of peripheral devices on before turning on this unit’s power.

•Depending on the sync generator and cables, the external synchronizing signal may be attenuated when multiple players are connected, and this may keep the external sync function from operating.

•The external sync function synchronizes with the video signal’s waveform, not with the timing of the picture. To synchronize with the picture, use a separate controller.